BaBylissMEN E856E Manual

HOW TO USE

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5

Fig. 6

Please carefully read the instructions for use below before using the appliance.

PRODUCT FEATURES

1. Blades:

• Moveable blade: CMS (Chrome-Molybdenum-Stainless Steel)
• Fixed Blade: stainless steel

2. 1 comb guide for 18 lengths (from 1 mm to 18 mm, in 1 mm increments)
3. ON-OFF button
4. Wheel to adjust the cutting length
5. LED display window of the cutting length
6. Charging indicator light
7. Accessories: adaptor, oil, cleaning brush

CHARGING THE TRIMMER

1. Plug the cord into the unit and connect the adaptor. Before using the unit for the first time, allow it to charge for 16 hours. Make sure the unit's switch is in the OFF position.
2. Check that the charging indicator light is lit.
3. A full charge provides a minimum of 60 minutes' use of the unit.
4. Subsequent charges should also be 8 hours.

REGARDING THE NI-MH BATTERIES OF THIS UNIT

To obtain and maintain the longest battery life possible, allow it to charge for 16 hours approximately every three months. Moreover, full battery life of the unit will only be obtained after three complete recharge cycles (one cycle of 16 hours followed by two cycles of 8 hours).

USE ON THE MAINS

To use the unit on the mains, plug the cord directly into the unit. Plug the unit, in the OFF position, into the mains and switch ON (if the battery is very weak, wait about 1 minute).
Use only the adaptor that is supplied with the trimmer.

HANDLING THE COMB GUIDE

NOTE:
Always put the comb guide on BEFORE turning the unit on, and turn the unit off before removing the comb guide.

• To remove the comb guide, first set the comb guide beyond position 18 and, with the motor off, pull the comb guide up to remove it (Fig. 1),
• To replace the comb guide, press the comb guide down then turn the wheel to put it on and to select the desired cutting length (Fig. 2).

TURNING IT ON AND USING IT

To adjust the cutting length of the trimmer, turn the wheel. Switch the ON/OFF button. The selected cutting length is displayed on the LED display window. You can change the cutting length at any time.
NOTE!
Make sure you hold the comb guide head flat against the skin. That is, the tips of the teeth and the little corners protruding from the comb should always be in contact with the skin. If not, the precision of the cut may change (Fig. 3-4).

MAINTENANCE

Cleaning the trimmer blades regularly will maintain their optimal performance.

Removable blades
To make cleaning easier, the BaByliss trimmer blades can be removed. Make sure that the trimmer is off and remove the cutting guide. Hold the trimmer with the blades pointing up and remove them by pressing their points.(Fig. 5).
Carefully brush the blades using the cleaning brush to remove hair.
Rinse the blades. The device must never come into contact with water. Let the blades dry in the open air before putting them back onto the device.

Self-lubricating blades
The blades of your trimmer have a reservoir pad for releasing the necessary amount of oil for proper operation of your trimmer, time after time. Nevertheless, it is recommended that it be refilled occasionally when you notice performance is not as high.
Remove the blades as described above.
Squeeze a few drops of BaByliss oil onto the pad (Fig. 6). Then replace the blades on the trimmer.
The BaByliss oil is specially formulated for the trimmer, it does not evaporate nor does it slow the blades.
It is possible to obtain replacement blades when these are worn out or damaged.

BABYLISS
99 avenue Aristide Briand
92120 Montrouge
France

www.babyliss.com