HUAWEI MU739 HSPA+ LGA Module Development Board Guide Contents Contents 1 Overview ............................5 1.1 About This Chapter ........................... 5 1.2 Introduction to the DVK ........................5 1.3 Components of the DVK ........................6 2 Overview of the DVK........................7 2.1 About This Chapter ...........................
Two antenna connectors The MU739 module is soldered onto the interface board in a manner that is similar to the surface mounting of chips. The signals output from the module are transferred to the development board for secondary development.
HUAWEI MU739 HSPA+ LGA Module Development Board Guide Overview 1.3 Components of the DVK Table 1-1 lists the components of the DVK. Check the components and their quantities after you obtain the DVK. If any component is missing or damaged, contact your DVK supplier.
HUAWEI MU739 HSPA+ LGA Module Development Board Guide Overview of the DVK Overview of the DVK 2.1 About This Chapter This chapter describes the structure, interface functions, and interface usage of the DVK development board. DVK Development Board Structure ...
Page 8
HUAWEI MU739 HSPA+ LGA Module Development Board Guide Overview of the DVK 1. 5 V power supply input interface Power supply selecting jump Mini USB port GND pins Output pins of DC-DC in base board W-DISABLE control jump Joint Test Action Group (JTAG) interface...
Figure 2-1 ), it is a standard RS-232 serial communication interface, which supports 4-wire serial communication and can be connected to a PC or other DTE through a RS-232 serial cable. The serial communications interface is used for Huawei internal debug and cannot be used by customer.
HUAWEI MU739 HSPA+ LGA Module Development Board Guide Overview of the DVK 2.3.7 Antenna Connector The DVK development board provides two antenna connectors. One is the primary antenna interface J701 (as red circle 8 in Figure 2-1 ), the other is the diversity antenna interface J702 (as red circle 9 in Figure 2-1 ).
HUAWEI MU739 HSPA+ LGA Module Development Board Guide Overview of the DVK Position Mark on the Usage and Configuration Figure Number Development Board J404 J404 (as red This jump is used to start the module. circle 11 in Configuration is needed. The module can...