General Information - Norden Tie Grabber Series Owner's Manual

High- Pressure Hazard
Do not make any temporary repairs to the
hydraulic lines, fittings, or hoses using
tape, clamps, or cement. The hydraulic
system operates under extremely high pressure
and temporary repairs may fail suddenly and
create a hazardous and/or dangerous situation.
The following safety instructions are provided to help
prevent injury or limit equipment damage.
Safety Equipment
A fire extinguisher and first air kit should
be readily accessible while performing
Norden Mfg (877) 296-5851
maintenance on this unit.
Clean Work Area
Do not leave tools lying around the work area.
Follow good shop practices. Keep service area
clean and dry. Be sure electrical outlets and
tools are properly grounded. Use adequate light.
Use the Right Tools
Use the correct tools, jacks, hoists, or other
tools that have capacity for the job.
NOTE: After working on the Hydraulic system cycle
the unit two or three times to bleed the system and let
any air out of the lines.

11.2 General Information

Preventive maintenance is one of the most cost-
effective practices that any equipment owner can
implement. Taking a few minutes of your time to
inspect the Tie Grabber can save hundreds or even
thousands of dollars. These savings can come from:
1. Increased operating time (no unscheduled
breakdowns in the field).
2. Normal wear items will last longer because they
have been properly maintained and lubricated.
3. Less chance of someone becoming injured due to
parts that fail because of mistreatment or abuse.
Preventive maintenance should only be completed
by qualified persons. In no way are these instructions
intended to encourage service of the unit by anyone
who is not qualified to do so. The overall performance
of the unit is directly related to the skill and knowledge
of the person performing the service. If the mechanic
cannot see potential problems, or is unaware of the
signs of potential problems, the service may be a
costly waste of time.
35 Tie Grabber