Avalanche Update Using File | Settings; Menu Options - LXE MX8 Reference Manual

Wavelink Avalanche Enabler Configuration
Option
Settings
Scan Config
Exit

Avalanche Update using File | Settings

Access:
Use these menu options to setup the Avalanche Enabler on the mobile device. LXE recommends
changing and then saving the changes (reboot) before connecting to the network.
Alternatively, the Mobile Device Server can be disabled until needed (refer to the Wavelink
Avalanche Mobility Center User's Guide for details – available on the Wavelink Avalanche
website).

Menu Options

Option
Connection
Execution
E-EQ-MX8RG-C
Function
The Settings option under the File menu allows the user to access the control
panel to locally configure the Enabler settings. The Enabler control panel is, by
default, password protected. The default password is
system
The password is not case-sensitive.
Note: LXE does not support the Scan Configuration feature on Windows CE
devices. The Scan Config option under the File menu allows the user to
configure Enabler settings using a special barcode that can be created using the
Avalanche Management Console utilities. Refer to the Wavelink Avalanche
Mobility Center User's Guide for details.
The Exit option is password protected. The default password is
leave
The password is not case-sensitive.
If changes were made on the Startup/Shutdown tab screen, then after entering the
password, tap OK and the following screen is displayed:
Change the option if desired. Tap the X button to cancel Exit. Tap the OK button
to exit the Avalanche applet.
Start | Avalanche | File | Settings
Function
Enter the IP Address or host name of the Mobile Device Server. Set the
order in which serial ports or RF are used to check for the presence of
the Mobile Device Server.
Unavailable in this release. LXE recommends using AppLock, which
is resident on each Windows CE mobile device. See Chapter 6 -
AppLock.
133
MX8 Reference Guide