Table of Contents
Advertisement
Unit's Diagnostics
Type
Read Current Unit
Profile
Modem TX Audio
Pre-Emphasis
Ethernet Address
Force Alarm
Force DCD
User Help
MDS 05-4670A01, Rev. E
NOTE: The radio is configured by default to be in DLINK mode. The
port automatically determines the connected baud rate
COM1
(within the range of 1200–115200 bps). Enter a series of
Return Key presses about a half second apart until the
appears. This indicates that the radio is ready to receive
commands.
DTYPE [NODE/ROOT]
This command establishes the local radio as a root radio or node radio
for network-wide diagnostics. Entering
radio as a node radio. Entering
radio. Entering the
DTYPE
DUMP
This command causes all of the programmed settings to be displayed.
EMP [ON/OFF]
This command displays or sets the TX pre-emphasis and RX
De-Emphasis when the radio is operating with the analog mode and the
radio's MODEM is turned off (
the other radios in the system. The use of pre- and de-emphasis can help
reduce the detrimental influence of high frequency audio noise.
ETHADDR
Displays programmed Ethernet MAC address (set at the factory).
FORCEALARM [ON or OFF]
Generates a test alarm for 10 sec. Use to test alarm outputs and
switch-over in redundant systems.
FORCEDCD [ON or OFF]
Forces Data Carrier Detect (DCD) to always be asserted. Use when con-
necting to equipment that requires a constant DCD indication.
HELP
Show available commands.
SD Series Reference Manual (x710 Mode)
DTYPE NODE
configures the radio as a root
DTYPE ROOT
command alone displays the current setting.
). It should be set to match
MODEM NONE
prompt
>
configures the
29
Advertisement
Table of Contents
