(1) Test pin
This pin is used for testing the analog signals of the standalone emulator.
• TP1: GND
These are test pins for checking the product. Do not use.
• TP2: VDD
• TP6: LVDD
• TP9: TVDD1
• TP11: MKVDD
• TP14: QVDD
• TP18: +12 V
(2) TP16
This is the pin for supplying SMVDD.
(3) LED
LED1 for VDDn. (n = 0, 2, 3)
ON: Voltage is applied to VDDn.
OFF: Voltage is not applied to VDDn.
LED2 for SMVDDn. (n = 0, 1)
ON: Voltage is applied to SMVDDn.
OFF: Voltage is not applied to SMVDDn.
LED3 for AVDD.
ON: Voltage is applied to AVDD.
OFF: Voltage is not applied to AVDD.
(4) IE-703002-MC connection
This is the connector for connecting to the IE-703002-MC.
(5) Target connection
This is the connector for connecting to the target system or the extension probe.
2.2 Clock Settings
This section describes the clock settings.
For the jumper switch position in the IE-703002-MC, refer to the IE-703002-MC User's Manual.
IE-703002-MC
JP2
SW1
SW2
Note The target clock is not supported.
2.3 Illegal Access Detection ROM Setting
If using the IE-703002-MC as an in-circuit emulator for the V850/DB1 by connecting the IE-703081-MC-EM1,
set JP1 of the IE-703081-MC as follows.
IE-703002-MC
JP1
Setting
7
8
ON
OFF
Setting
Open
13
1
2
IE-703081-MC-EM1 User's Manual