Table of Contents
Advertisement
4/9/22, 4:44 PM
Due to the nature of quartz crystal, a significantly different heating profile is required to produce optimal vapor
density and flavor. This mode is specifically calibrated for the Dr. Dabber Crystal Induction Cup (sold
separately).
This mode is not suitable for the standard Ceramic Induction cup
To access Crystal Mode, the SWITCH must be powered down from Advanced Mode.
Hold down the (+) button and power on the device by flipping the power switch to either (LEAF)or (OIL).
The front LEDs will illuminate White to indicate Crystal Mode.
Release the (+) button.
If the front LED display illuminates Rainbow, it indicates the device was already in Crystal Mode and has
returned to Advanced Mode. Repeat the above process to get back into Crystal Mode
Press the (+) or (-) button to display the current Power Setting.
Press or hold the (+) or (-) buttons again to increase or decrease the Power Setting.
1 Purple LED is the lowest Power Setting (profile equivalent to 300 degree range).
1 Orange LED is the Highest Power Setting (profile equivalent to 800 degree range).
Wait 5 seconds for the Power Setting to save, or immediately save the Power Setting by pressing the (Go)
button.
After the Power Setting is saved, the front LEDs will illuminate Pink to display the units battery level.
This mode is included for those who want even more flexibility in tuning in their ideal temperature.
Higher heat profiles may result in reduced battery life.
To change from Crystal Mode to Standard Mode, press and hold the (Go) button while the device is in an off
position, then power on the device by flipping the power switch to either (LEAF)or (OIL). This will restart the
device in the standard (LEAF)or (OIL) Mode.
To change from Crystal Mode to Advanced Mode, press and hold the (+) button while the device is in an off
position, then power on the device by flipping the power switch to either (LEAF)or (OIL). This will restart the
device in the Advanced Mode.
The Self Cleaning Cycle is NOT available in Crystal Mode. Please see 'Cleaning Your Switch' section for
instructions on how to clean your Crystal Induction Cup.
RED and BLUE flashing LEDs indicate an internal error has occurred with your device. Upon the SWITCH
entering the RED and BLUE flashing sequence, turn the device off by returning the Power SWITCH to the
center position and follow the directions below.
https://drdabber.helpscoutdocs.com/article/76-switch-user-manaul
Switch User Manual - Dr. Dabber Knowledge Base
Troubleshooting
15/18
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the SWITCH and is the answer not in the manual?
Questions and answers