Page 1
USER MANUAL VRT330 - VRT350 - Vertical Juicer L O W S P E E D M A S T I C A T I N G J U I C E R www.OmegaJuicers.com 2014 JUNE...
Page 2
Omega thanks you for supporting us for over 50 years! Join us on Twitter @OmegaAppliances &/or on Facebook @OmegaJuicers PROdUCT ReGISTRATION, vISIT: www.omegajuicers.com/omega-warranty-registration ReCIPeS, vISIT: www.omegajuicers.com/recipes CUSTOmeR SeRvICe: Call 1-800-633-3401 or visit: www.omegajuicers.com/contact-omega-juicers After using your Omega, we kindly ask you to rate the machine on www.OmegaJuicers.com...
Page 5
SAFETY FIRST When using electrical appliances, basic safety precautions should always be followed including the following. READ ALL INSTRUCTIONS BEFORE USING. To protect against electrical shock, do not immerse cord, plug, or main body (motor) in water or other liquid. Close supervision is necessary when any appliance is used by or near children.
Page 7
KNOW YOUR OMEGA (See Illustration Below) (See Illustration Below) Pusher Hopper Wide Feed Chute Close Safety Locking System Auto Cleaning System Pulp Outlet High Performance Motor Sturdy Nonslip Feet Ultem Juice Screen Juice Spout On/Off (In rear) Heavy Duty Ultem Auger...
Page 9
QUICK START ASSEMBLY IMPORTANT As shown below, the hopper edge must point to “close” sign on the base in order for the machine to operate properly. Close Pusher Spinning Brush Cleaning Brush Hopper Silicon Brush Pulp Container Auger Juice Bowl Juice Container Juice Screen Base...
Page 11
HOW TO ASSEMBLE Place the screen into the auto clean brush. Screen Auto Cleaning Brush Place the screen and the auto clean Red Dot brush into the bowl, making sure the red on Screen dot on the screen and the red dot on the bowl are aligned.
Page 13
OpERATING INSTRUCTIONS ON/REV BUTTON Press [ON] button to start. [On] On [REV] Reverse Gradually put the ingredients into the hopper chute and press down with the pusher. After the extraction is complete, place [On] On the switch in stop position to stop. WARNINg When using [ON] or [Rev] Stop button, make sure that the auger stops...
SpINNING BRUSH ASSEMBLY, DISASSEMBLY AND WASHING...
Page 15
SpINNING BRUSH ASSEMBLY, DISASSEMBLY AND WASHING SpINNING BRUSH ASSEMBLY Spinning Brush Check the groove of the spinning brush Silicone Brush and the direction of silicone brush. • As shown to the left, let groove inserts (Longer Part) face the spinning brush. Brush Grove Down...
Page 17
BOWL pACKING ASSEMBLY As shown to the left in the dotted circle, let the protrusion part on the bowl packing face upward and hold it, like pinching, with your thumb and index finger. Bowl Packing • I nsert the bottom of the bowl packing into the bowl hole and fully press it down.
Page 19
You can thoroughly wash parts by immersing in warm water diluted with one or two drops of baking soda or dishwashing soap for about 30 minutes. When finished using the Omega® Nutrition System, simply put parts into dishwasher, on top rack. CLEANING BETWEEN RECIpES...
Page 21
pRECAUTIONS FOR SAFE USE All users of this appliance must read and understand these safety precautions before operating. SIGN SAMpLES This sign indicates contents that may cause risk of a fire or an electrical shock. Specific warnings are written in the sign. This sign indicates prohibited acts.
Page 22
pRECAUTIONS FOR SAFE USE DO NOT MOISTEN THE BASE OR SPLASH WATER ON THE BASE. Be careful not to let any liquids or other substances get into the switch on the appliance. DO NOT OPERATE THE SWITCH WITH WET HANDS. It may cause electric shock or a fire.
Page 23
pRECAUTIONS FOR SAFE USE DURING THE OPERATION, DO NOT ATTEMPT TO MOVE THE BASE, DISASSEMBLE THE BOWL SET OR PARTS AND TRY TO LOCK THEM. It may cause an injury or a failure. Any act of event needed, switch off first and unplug the power cord.
Page 25
IF THE AUGER STOpS WORKING Press [Rev] button for 3 to 5 seconds, then release. When the [Rev] button is released, the auger will stop rotating. Repeat this 2 to 3 times. The [Rev] button pushes the ingredients upward releasing the food clog.
Page 27
HINTS & TIpS • Use caution when juicing the following ingredients: - Fruits with seeds that are hard to chew should be pitted before extraction. Fruits such as plums, peaches, and apricots. - Stalk vegetables with strong fiber should be cut into smaller sizes of 1 to 2 inches before placing in the hopper.
Page 29
• Make sure the appliance is assembled according to the instructions in this manual. Refer to the instructions. • If the appliance still does not work, please contact Omega Customer Service for additional support. The Hopper Does Not Open •...
Page 31
SpECIFICATIONS Product Name VERT Low Speed Juicing System Model Name VRT330/VRT350 Rated Voltage 120 V Rated Frequency 60 Hz Rated Power Consumption 150 W 80 rpm Cord Length 55” (1.4 mm) Motor Single-phase induction motor Weight 22 lb (10 kg) Outward Dimension 7”...
Page 33
Clean Boost What You’ll Need: How To Prepare: ½ a beetroot Cut product to fit into hopper. 5 spinach leaves Juice in an Omega Juicer. ¼ cabbage 1 broccoli stick Pour over ice. ½ a grapefruit ½ a lemon Enjoy!
Page 34
RECIpES Total Health Booster What You’ll Need: How To Prepare: 1 medium apple, cored and cubed In your Omega Juicer, juice apple, 2 medium soft pears, pears, and cherries. cored and cubed Before serving, garnish with ½ cup fresh cherries fresh cherries, if desired.
Page 35
What You’ll Need: How To Prepare: 1 peach (remove pit) Cut produce to fit hopper. 1 mango (peeled and seed removed) In your Omega Juicer, juice peach, 1 orange (skin removed) mango and orange. ½ cup coconut water 1 teaspoon agave nectar Add remaining ingredients and stir.
Page 36
Nourish Your Body Enrich Your Soul Discover the complete line of Omega brand professional products at www.OmegaJuicers.com 6291 Lyters Lane • Harrisburg, PA 17111, USA • T: 1.800.633.3401 • F: 717.561.1298...
Need help?
Do you have a question about the VRT350 and is the answer not in the manual?
Questions and answers