Advertisement
Quick Links
Advertisement
Summary of Contents for VideoWave Adam Device
- Page 1 Wave Video User Guide Adam Device Version 3.7, February 2019 Wave © 2019 Video Networks inc., tous droits réservés Wave Video 7493 Trans-Canada Highway info@videowave.ca #103 Tel.: 514.789.0874 St-Laurent (Quebec) Toll-Free: 1.855.789.0820 www.videowave.ca Canada, H4T 1T3 Fax.: 514.789.0878...
- Page 2 Wave Adam Device- © 2019 Video Wave Video Networks inc. © 2019, all rights reserved : (514) 789-0874 : info@videowave.ca...
-
Page 3: Table Of Contents
Wave Adam Device- © 2019 Video Table of content Table of content Introduction Installing and configuring the ADAM device Connecting the alarm device Configuring the ADAM device Configuring the ADAM device in OneTrack Assembly diagram Connection diagram I / O... -
Page 4: Introduction
Wave Adam Device- © 2019 Video C h a p t e r 1 Introduction To facilitate the installation and configuration of the ADAM IP Alarm device, this guide will provide an installer with all the necessary steps for the product... -
Page 5: Installing And Configuring The Adam Device
Installing and configuring the ADAM device Connecting the alarm device Power the ADAM device with a 12VDC / 1A adapter (sold separately), then connect the alarm box to the network, on a switch port. For more details, please refer to the diagram below. -
Page 6: Configuring The Adam Device
Wave Adam Device- © 2019 Video Configuring the ADAM device To configure the IP ADAM alarm box, please follow the procedure below. Start the ADAM / Apax Configuration Tool .NET Utility Right-click the "Ethernet" icon and select the "Search Device" option. - Page 7 I/O configuration screen should appear on the right. In order to test the correct functioning of the ADAM device, click on each of the buttons identified "DO - X", you must hear a click, which corresponds to a switching of the module relay. For alarm inputs, use a wire between the "DI-X"...
-
Page 8: Configuring The Adam Device In Onetrack
"FSV" mode and set it to 120 sec. This function is located under the "Network" tab. Configuring the ADAM device in OneTrack The following steps are required to configure the ADAM alarm device in the OneTrack system. - Page 9 Wave Adam Device- © 2019 Video In the "Inputs" and "Outputs" sections, you can assign names and specify the type of relay or input according to the parameters of your alarm panel (ie: NO or NC). With regard to the reliability relay, you can assign this relay the following status: "Reliability (Normally Closed)".
-
Page 10: Assembly Diagram
Wave Adam Device- © 2019 Video Assembly diagram Here is the procedure for mounting the ADAM device support. This type of mounting allows installation on the wall. Unscrew the 2 screws at the front of the device, then attach the bracket to... -
Page 11: Connection Diagram I / O
Wave Adam Device- © 2019 Video Connection diagram I / O The connection diagrams of the inputs and outputs of the IP ADAM device. A "dry contact" type input acts as a switch. Therefore, make the connection between the DI-X pin and the Iso. GND. -
Page 12: Troubleshooting
Wave Adam Device- © 2019 Video Troubleshooting If the IP communication loss is located on the ADAM device, please follow the following procedure: ISSUE NO POE Communication IP Check IP communication by PING command Network cabling Check the cable for proper operation...
Need help?
Do you have a question about the Adam Device and is the answer not in the manual?
Questions and answers