Service Receiver Authorization; Pc Modem; Remote Telephone Number; Remote Disarm - DMP Electronics COMMAND PROCESSOR XR100 Series Programming Manual

6.7
NO YES
SVC RCVR
6.8 PC MODEM NO YES
6.9
REMOTE PHONE NO.
-
-
NBR RMT PICKUP NUMBER - The panel allows you to enter into the keypad a phone number you want
6.10 DISARM NO YES
XR100 Series Programming Guide

Service Receiver Authorization

YES enables remote commands and programming to be accepted from a secondary
service receiver other than the alarm SCS-1R Receiver. The Remote Key option can
also be required.
With YES selected, the panel requests the service receiver key the first time it is
contacted by the service receiver. The panel retains this service receiver key in
memory and accepts remote commands from the service receiver.
If an alarm occurs during a remote connect, the panel disconnects from the service
receiver and calls the alarm receiver. Alarm reports are only sent to the alarm
receiver. It is important that the alarm receiver key and the service receiver key
programmed at the central station are NOT the same so the panel can determine the
difference between receivers.
When NO is selected remote commands and programming are not accepted from a
secondary service receiver.
This option must be YES to allow programming from a directly connected computer
or an iCOM/iCOM-E.

PC Modem

YES allows the panel to answer the telco link and connect with Remote Link through
the PC Modem at 2400 baud. NO disables PC Modem communication.

Remote Telephone Number

Press COMMAND to enter the phone number the panel dials when requesting remote
programming. After entering a phone number, the panel allows remote commands
and programming only after it has first been called by the authorized receiver,
disconnected itself, and redialed the remote phone number.
If a Remote Phone Number is NOT entered, and Alarm Receiver and Service Receiver
is YES the panel allows remote commands and programming without disconnecting
and redialing. The phone number can have two lines of 16 characters each to
equal 32. Enter a P to program a two second pause in the dialing sequence. The
P character counts as part of the 32 allowable characters. Enter *70P as the string
first characters to cancel call waiting. No dial tone detect "D" is required. Dial
tone detect is an automatic panel function.
Note: When not in the Programming Menu, the function 984 + COMMAND can be
entered at the keypad, and a remote options menu appears. This menu contains the
following options:
the panel to dial. Enter any required prefixes and area codes.
REMOTE - The panel dials the phone number programmed in Remote Phone Number.
PICKUP - The panel picks up the phone line when Remote Link™ calls in. The phone
must be ringing before selecting PICKUP.
See the Appendix for more information about the 984 + COMMAND feature.

Remote Disarm

YES allows the panel to be disarmed remotely. NO disables remote disarming.
REMOTE OPTIONS
Digital Monitoring Products
21