Electrolux EFP 4200 Manual page 42

g
During operation further ingredi-
3
ents can be added through the fill-
ing inlet. The sealing cover (fig.
1/D) can also be used as a filling
beaker for this purpose. Close the
filling inlet again immediately every
time to avoid splashing.
0 Start the mixer: turn speed selec-
tor (fig. 1/l) to the right to the
desired speed or press the pulse
button (fig. 1/J).
3 It is recommended to start at a
slow speed and then to increase
the speed. The mixer operates at
maximum speed by pressing the
pulse button.
Refer to the section "Tips on using
mixer" for reference values for set-
ting the speed.
0 Switch off appliance: turn speed
selector left to "0" position.
0 After mixing, turn container clock-
wise and remove. Then turn the
cover and remove.
Multifunction section
Tools and their application
possibilities
(depending on model)
The following tools can be used in
the multifunction section:
• Whisking disk (fig. 1/R)
• Metal blade (fig. 1/Q)
• Plastic blade (fig. 1/P)
• Insert holder (fig. 1/O) with cut-
ting insert (fig. 10)
The inserts are marked by a number
(1 to 6) on the handle. The desired
insert is placed in the insert holder.
1 Fine cutter
PG1Potato grater
3 French fries cutter
4 Cheese grater
5 Fine rasp
6 Coarse rasp
44
www.preciz.hu
Preparing multifunction
section
Fit safety cover (fig. 4)
The multifunction section can only
be put into operation when the mix
container is removed and the
safety cover for the mixer drive
(figs. 1/T and 4) is fitted.
0 Remove mix container as
described under "Mixer".
– The red warning lamp (fig 4/a)
flashes.
0 Place safety cover on mixer drive
(mark
counter-clockwise to the stop.
The safety cover is heard to
engage (mark
– The red warning lamp (fig. 4/a)
extinguishes.
Fitting all-purpose bowl
(fig. 5)
– The red warning lamp (fig 4/a)
flashes.
0 Place all-purpose bowl (fig. 1/G) on
appliance (mark
and turn counter-clockwise to the
stop. The all-purpose bowl can be
heard to engage (mark
mark
– The red warning lamp (fig. 4/a)
extinguishes.
Inserting spindle (fig. 7)
0 Place spindle (fig. 1/H) on spigot in
centre of all-purpose bowl.
Inserting tools
The following tools can be
selected for insertion:
• Whisking disk (fig. 1/R) or
• Metal blade (fig. 1/Q) or
• Plastic blade (fig. 1/P) or
• Insert holder (fig. 1/O) with cutting
insert (fig. 9)
The insert holder must be fitted
3
with the appropriate insert
on mark ) and turn
on mark
on mark
).
).
)
on