Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Prominence Home Montauk
Summary of Contents for Prominence Home Montauk
-
Page 2: Package Contents
PACKAGE CONTENTS Unpack your fan and check the contents. You should have the following items: PACKAGE CONTENTS 1. Canopy 10. Closemount Screw (x3) 2. Canopy Cover 11. Motor Assembly 3. Mounting Bracket 12. Motor Screw (x10) 4. Mounting Bracket Screw 13. -
Page 3: Mounting Options
DIMENSION REFERENCE A. 12.53 in. B. 10.86 in. C. 11.38 in. D. 5.13 in. MOUNTING OPTIONS Three Mounting Options Downrod Mount Closemount Angle Ceiling Mount (Up to 16 degrees) Choose one of the following mounting options: Closemount method is best suited for ceilings lower than 8 feet. It does not utilize the downrod. Downrod Mount is best suited for ceilings 8 ft. -
Page 4: Safety Instructions
SAFETY INSTRUCTIONS READ ALL SAFETY INFORMATION AND INSTALLATION INSTRUCTIONS BEFORE YOU BEGIN INSTALLING THE FAN AND SAVE INSTRUCTIONS. CAUTION: All set screws of the fan must be checked and retightened where necessary before installation. To reduce the risk of personal injury, do not bend the blade brackets when installing the brackets, balancing the blades or cleaning fan. - Page 5 SAFETY INSTRUCTIONS WARNING: To avoid risk of electric shock, be sure to shut off power at the main fuse or circuit breaker box before installing or servicing this fixture. Turning off the electrical power by using the light switch is not sufficient to prevent electrical shock.
- Page 6 ASSEMBLY INSTRUCTIONS 1. Turn OFF the electrical power at the main fuse or circuit breaker. DANGER: Failure to disconnect the power supply prior to installation may result in serious injury or death. 2. Remove the mounting bracket by removing the two mounting bracket screws from the round holes in the Mounting Bracket Screw canopy.
- Page 7 ASSEMBLY INSTRUCTIONS DOWNROD INSTALLATION: Downrod Clip 5. Remove the downrod clip and downrod pin from the Downrod downrod. Then partially loosen the two set screws in the yoke at the top of the motor assembly. Downrod Pin Yoke Set Screw 6.
- Page 8 ASSEMBLY INSTRUCTIONS 9. Use wire connectors to connect the fan wires to the Black (hot) power supply wires according to the wiring diagram and the following instructions: White (neutral) Wire Bare/Green Connector • Connect the white wire from the fan to the white (ground) (neutral/common) supply wire.
- Page 9 ASSEMBLY INSTRUCTIONS 13. Attach the pull chain extension to the pull chain. Fitter Plate Fitter Plate Screw Pull Chain Extension 14. Turn ON the electrical power at the main fuse or circuit breaker and the wall switch. Installation is complete.
- Page 10 OPERATING INSTRUCTIONS 1. The fan pull chain has four positions to control fan speed. One pull is HIGH, two is MEDIUM, three is LOW and four turns the fan OFF. Fan Pull Chain 2. Use the reverse switch, located on the switch housing to optimize your fan for seasonal performance.
-
Page 11: Troubleshooting
TROUBLESHOOTING If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check the Troubleshooting section below. If a problem cannot be remedied or you are experiencing difficulty in , 8 a.m.-5 p.m. -
Page 12: Limited Lifetime Warranty
LIMITED LIFETIME WARRANTY To obtain service, please contact the Service Department: , 8 a.m.-5 p.m. Central, Monday-Friday. 1-877-706-3267 Model Name: 52” Ceiling Fan Model No: 51589 - Espresso 51590 - White Set forth below, the manufacturer, Hong Kong China Electric appliance Company (HKC) warrants the fan motor for this ceiling fan to be free from defects in workmanship and material for the life of the product.
Need help?
Do you have a question about the Montauk and is the answer not in the manual?
Questions and answers