Bluetooth Mode; Maintenance And Care - Kenwood LS-600BT Operating Instructions Manual

6.5 BLUETOOTH mode

Switch on the Soundbar and briefly press the <STANDBY> button on the Soundbar or the <Input>
button on the remote control to switch the Soundbar to BLUETOOTH Mode. The LED indicator "bt"
on the Soundbar starts flashing in the BLUETOOTH-Pairing-Mode and you hear a series of tones.
• Switch on the BLUETOOTH on your device, search for "LS-600BT" in the BLUETOOTH and then
select the BLUETOOTH connection.
• If the pairing is successful, you will hear a tone and the "bt" indicator stops flashing. Then the
music on your telephone or another compatible device that you have selected can be played on the
Soundbar.
• Press and the hold the <PAIR> button on the remote control for longer than two seconds to
disconnect the connection to the paired BLUETOOTH device or to reconnect the previously
disconnected BLUETOOTH device.
• Control the playback using the <Playback/Pause>, <Skip track forwards> and <Skip track
backwards> buttons.
• Set the volume and the sound mode with the corresponding button on the remote control.
Please note:
The pairing process described above must not be repeated with the same device once paired. If the
connected device is switched off or manually disconnected, the Soundbar automatically switches to
the Pairing mode.
If the connected device is removed out of the range of the Soundbar (up to 10 meters), the
connection is disconnected and the Soundbar is successfully connected to the device as soon as it is
once again in within the range. To setup a connection with another device, repeat the above pairing
steps. If a BLUETOOTH was already connected, the Soundbar connects with the last connected
device. Disconnect this connection to connect a new device. There is no automatic shut-down in the
Pairing mode. The Soundbar remains in the Pairing mode even if no device is paired.

7. Maintenance and care

Cleaning the housing
Use a cloth lightly moistened with a mild detergent. Do not use detergents containing alcohol,
ammonia or scouring agents.
Cautions on condensation
Condensation (dew) may form inside the unit if there is a significant difference between the
temperature of the unit and the ambient temperature. If condensation occurs inside the unit, proper
function is no longer guaranteed. In this case, you have to wait a few hours; After the moisture has
dried, the device can be reused.
Special care should be taken in the following circumstances
When the unit is moved from one place to another at a much higher or lower temperature, or when
the humidity at the installation site increases, etc.
13