Removal And Installation; Turbocharger Weights; Removing The Turbocharger - ABB HT576419 Operation Manual

Operation Manual / TPL65-A32 / -A33 / -A36 + TPL69-A32 / -A33
7 Removal and installation / 7.1 Turbocharger weights

7 Removal and installation

7.1 Turbocharger weights

Weights [kg]

7.2 Removing the turbocharger

© Copyright 2018 . All rights reserved.
Lifting gear with a sufficient load limit must be used for removing and
installing the turbocharger. The following weight specification is the
heaviest variant possible. This standard value may deviate from the data
on the rating plate depending on the specification.
TPL65-A32/-A33/ -A36
1230
Disconnect all gas, air and oil lines in accordance with engine manu-
u
facturer's instructions.
CAUTION
Oil orifice plates
An orifice plate for adjusting the oil pressure is fitted in each of the two
oil inlet channels in the bearing casing. When the cartridge group, the
bearing casing or the turbocharger is fitted to the engine, it must be
ensured that the orifice plates that are specified for the turbocharger
have been installed in the two oil inlet channels.
Check correct installation of oil orifice plates.
u
Unplug the cable connector on the speed sensor.
u
Remove the insulation at the suspension ribs.
u
TPL65: Version with compressor wheel cooling system
Remove air supply line. (See also chapter entitled Preliminary re-
u
marks / Layout and functionality)
Inspect the lifting gear.
u
HZTL2498_EN
TPL69-A32 / -A33
1780
Revision C April 2018