Table of Contents
Advertisement
Quick Links
The Ion-Edge is a highly effective AC static neutralization system. Please read the following
instructions carefully to ensure correct installation, safe operation and peak performance.
MODEL 200 POWER SUPPLY
The Model 200 Power Supply is a highly reliable unit that supplies 6000 volts of AC current to the
Ion-Edge Bar.
ELECTRICAL REQUIREMENTS
A 6
⁄
foot grounded power cord is supplied with the power supply. The unit must be plugged into a
1
2
grounded outlet or wired to a grounded control box.
Ratings
Input Volts: 115VAC Standard (220VAC optional)
Output Volts: 6000VAC
Cycles: 50/60
Starting Load: <0.5 amps
Running Load: <0.5 amps
MOUNTINg ThE POWER SUPPLY
The Power Supply can be mounted to any solid surface via the mounting tabs extending out from the
bottom side of the unit or placing the unit in an enclosure. Keep in mind the positioning of the Ionizing
Bar when locating the Power Supply. A standard 6.5' (foot) power cable is supplied with the bar.
Once the unit has been mounted, switch the unit to the OFF position (the lighted rocker switch is
located on the side of the unit near the cord end—rock the switch downward) and then route the power
cord to the designated outlet. (The Power Supply can be wired directly to a machine switch so the unit
is only running when the machine is running and off when it is not.) The Power Supply is now ready to
receive the Ionizing Bar.
Note: Always keep the Power Supply powered OFF when the system is not in use. Unplug or
disconnect the power to the controller when the system is being serviced.
ThE IONIzINg BAR
The Ion-Edge bar is a one piece, lightweight unit. The in-line high voltage cable has a screw-in type
connector enabling quick and easy hook-up to the power supply.
At each end of the bar are positioned an
chain, not supplied. Longer bars will have mount studs and nuts positioned symmetrically in the middle
of the bar.
ion-EdgE ModEl 400T SEriES
inSTallaTion & opEraTing inSTrucTionS
⁄
stud and nuts that can be fastened to a mounting bracket or
8
32
Advertisement
Table of Contents
Related Manuals for Takk 400T Series
Summary of Contents for Takk 400T Series
- Page 1 ModEl 400T SEriES inSTallaTion & opEraTing inSTrucTionS The Ion-Edge is a highly effective AC static neutralization system. Please read the following instructions carefully to ensure correct installation, safe operation and peak performance. MODEL 200 POWER SUPPLY The Model 200 Power Supply is a highly reliable unit that supplies 6000 volts of AC current to the Ion-Edge Bar.
- Page 2 Static Control Bar to the material. The only additional installation needed for the TAKK AirBar is to connect the air tubes of the Bar to an air supply using standard air fittings. The bar is fitted with a ⁄...
- Page 3 Ion Edge is guaranteed against any factory defects in materials and/or workmanship for a full 24 months from the date of purchase. Any equipment found to be defective by a qualified TAKK service technician will be repaired or replaced at TAKK’s cost. Any special handling or shipping the customer may request is not covered under this warranty.
- Page 4 A byproduct of the Ion-Edge Bar is ozone. The ozone emission from the Bar is less than 0.1ppm and well below OSHA standards providing safe working conditions around the system. TAKK INDUSTRIES INCORPORATED 8665 E. Miami River Rd. Cincinnati, Oh 45247 USA...
Need help?
Do you have a question about the 400T Series and is the answer not in the manual?
Questions and answers