Husqvarna QHIO760P User Manual page 36

36 www.husqvarna-electrolux.se
Problem
You cannot select the
maximum heat setting for
one of the cooking zones.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactiva‐
ted.
The hob deactivates.
Residual heat indicator
does not come on.
Hob²Hood does not work.
The sensor fields become
hot.
There is no sound when
you touch the panel sen‐
sor fields.
comes on.
The control bar blinks.
Possible cause
There is water or fat stains
on the control panel.
The other zones consume
the maximum available pow‐
er.
Your hob works properly.
You put something on one or
more sensor fields.
You put something on the
sensor field .
The zone is not hot because
it operated only for a short
time or the sensor is dam‐
aged.
You covered the control pan‐
el.
You use a very tall pot which
blocks the signal.
The cookware is too large or
you put it too near to the
controls.
The sounds are deactivated.
Child Safety Device or Lock
operates.
There is no cookware on the
zone or the zone is not fully
covered.
The cookware is unsuitable.
The diameter of the bottom
of the cookware is too small
for the zone.
Remedy
Clean the control panel.
Reduce the heat setting of the
other cooking zones connec‐
ted to the same phase.
Refer to "Power manage‐
ment".
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
If the zone operated sufficient‐
ly long to be hot, speak to an
Authorised Service Centre.
Remove the object from the
control panel.
Use a smaller pot, change the
cooking zone or operate the
hood manually.
Put large cookware on the rear
zones, if possible.
Activate the sounds.
Refer to "Daily use".
Refer to "Daily use".
Put cookware on the zone so
that it fully covers the cooking
zone.
Use suitable cookware. Refer
to "Hints and tips".
Use cookware with correct di‐
mensions. Refer to "Technical
data".