Setting Up The Riotboard Software - NXP Semiconductors FRDM-MC36XSD-EVB User Manual

NXP Semiconductors
RIoTboard
Header Pin
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40

8.2 Setting up the RIoTboard software

KTFRDMMC36XSDEVBUG
User guide
Hardware Header
name
GPIO5_06
CSPI2_CS0
GPIO5_07
CSPI2_CLK
GPIO5_08
UART3_RXD
GPIO4_26
UART3_TXD
GPIO4_27
UART4_RXD
CSPI3_RDY
UART4_TXD
I2C3_SCL
UART5_RXD
I2C3_SDA
UART5_TXD
I2C4_SCL
PWM1
I2C4_SDA
PWM2
GND
PWM3
The procedure for setting up the software that supports using the FRDM-MC36XSD-EVB
with a RIoTboard is as follows:
1. Go to the Tool Summary Page at
and click on the Jump Start icon. Locate and download the zip file named
tools_SVN2487(2016-1-22).zip. Unzip the file to a location on the host PC.
2. Connect a 5.0 V DC power supply to the RIoTboard.
3. Connect one end of a Mini USB cable to the USB OTG interface on the RIoTboard.
Connect the other end of the cable to the host PC.
4. Power down the board and set the boot switch (SW1) on the RIoTboard to serial
download mode, as shown below:
All information provided in this document is subject to legal disclaimers.
FRDM-MC36XSD-EVB
Pin Hardware
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
http://www.nxp.com/FRDM-MC36XSD-EVB
Rev. 1.0 — 30 August 2016
KTFRDMMC36XSDEVBUG
FRDM-MC36XSD-EVB evaluation board
name
— No connection
— No connection
— No connection
— No connection
— No connection
— No connection
— No connection
— No connection
— No connection
— No connection
— No connection
— No connection
— No connection
— No connection
— No connection
— No connection
— No connection
— No connection
— No connection
— No connection
Gnd Gnd
CLOCK Input clock
Description
© NXP B.V. 2016. All rights reserved
27 / 34