Advertisement
LP-F30F Connectors (2.0/3.0 mm type)
Step 1:
Insert the boot
and ring into the cable.
Step 3:
Strip off the
jacket from the Mark 3.
Step 5:
Strip off the
buffer and 250um
coating till Mark 1,
and keep 125um fiber.
Step 7:
Press the LP-F30F tool and then insert the
125um fiber to reach the innermost until the buffer
make a curve. Then release the tool and check if this
buffer is tight.
Step 9:
Release the
tape to take out the
LP-F30F connector,
and cut the extra yarn.
User Guide for SC Field Installable
Step 2:
Make a mark
on cable according to
MARK 3 of the length
chart.
Step 4:
Make marks
on buffer according to
the length chart
(Mark 1: The starting
point to strip the buffer.
Mark 2: Check point).
Step 6:
Follow the
LP-F30FTOOL FIBEr
CUTTEr MaNUaL
to cut the fiber
Step 8:
Place the yarn in the slot of both side, then
screw the ring.
Step 10:
Move the
boot toward to the
stopper.
Step 11:
Release the
tape to take out the
LP-F30F connector,
and done.
LPF30F_UG_ENB01W
MARK 3
MARK 2
MARK 1
www.lanpro.com
Advertisement
