Appendix; Io-Link Error Codes; Isdu Return Error Codes - Siemens SIMATIC RF200 System Manual

Appendix

To understand this appendix, you should be familiar with the "IOL_CALL" function.
A.1

IO-Link error codes

A.1.1

ISDU return error codes

S7-PCT, IOL_CALL and the IO-Link device (reader) use the frame transport layer "ISDU".
The following table lists possible ISDU return error codes. The ISDU return error codes are
not generated by the reader. You can display the error codes using the "IOL_CALL" function
block.
Error code Error description
(hex)
8000 Command error
8011 Index not available
8012 Subindex not available
8020 Service temporarily not available
8021 Service temporarily not available.
Local control unit blocked.
8022 Service temporarily not available.
Device is busy with another task.
8023 Access denied
8030 Parameter value is outside the permitted range
8031 Parameter value is above the limit
8032 Parameter value is below the limit
8033 Parameter length exceeded
8034 Parameter not long enough
8035 Function not available
8036 Function temporarily not available
8040 Invalid parameter set
8041 Invalid parameter set
8082 Application not ready
SIMATIC RF200 IO-Link
System Manual, 03/2012, C79000-G8976-C276-01
Remedy
-
Correct index
Correct subindex
Repeat query after a waiting time
Repeat query after a waiting time
Repeat query after a waiting time
Index can only be read
Transfer the correct value
Transfer the correct value
Transfer the correct value
Check parameter length
Check parameter length
Check call parameters
Repeat query after a waiting time
Transfer correct parameter set
Transfer correct parameter set
-
A
93