Transmitting A Message; Auto Answer Reply - Kenwood TH-D7A(G) Instruction Manual

TRANSMITTING A MESSAGE

When entry of a message (or bulletin) is completed, this
transceiver automatically starts transmitting it at intervals
of 1 minute. With a message entered, the transceiver
repeats transmitting up to 5 times until an
acknowledgment is returned. With a bulletin entered,
the transceiver always repeats transmitting 5 times; an
acknowledgment is not returned.
STA CON
7
5
The table given on page 20 also shows indicators that
appear for outgoing messages (or bulletins). You can also
manually transmit all of those regardless of the 5-minute
timer.
1 Press [MSG].
2 Press [UP]/ [DWN] to select "TRANSMIT".
3 Press [OK] to start transmitting.
• After transmission, the frequency display is restored.
22
96 96BCON BCONDUP
9
ST STA CON CON 96 96BCON BCONDUP
9
7
5

AUTO ANSWER REPLY

This transceiver is capable of automatically returning a
programmed message when any message is received.
1 Access Menu 2–J (AUTO REPLY), then press [OK].
ST STA CON CON
7
5
2 Press [UP]/ [DWN] to select "ON", then press [OK].
3 Access Menu 2–K (REPLY MSG), then press [OK].
• The display for entering a message appears; the first
digit blinks.
ST STA CON CON
7
5
4 Press [UP]/ [DWN] to select a character, then press
[OK].
• The cursor moves to the next digit.
• You can enter alphanumeric characters plus special
ASCII characters.
• You may use the keypad. For example, each press of
[TNC] switches entry as a, b, c, 2, A, B, then C. Press
[ENT] to switch among the special ASCII characters.
5 Repeat step 4 to enter a message with up to 45 digits.
• To complete programming after entering less than 45
digits, press [OK] twice.
96 96BCONDUP
9
96 96BCONDUP
9