Technical Specifications - Eureka Forbes AQUAGUARD CREST UV +HOT User Manual

TECHNICAL SPECIFICATIONS*

# TECHNICAL PARAMETER
1 Model
PRODUCT SPECIFICATION
1 Dimension (W X D X H)
2 Net weight
3 Purification Technology
4 Standard Purification supplied
ELECTRICAL SPECIFICATIONS
1 Power Rating
2 Power Supply
3 UV LAMP
4 UV Lamp life
5 Operating Voltage Range
RECOMMENDED INPUT WATER PARAMETERS
1 Input water pressure range**
2 Input Iron content (Max.)
3 Input Chlorine content (Max.)
4 Input water turbidity (Max.)
5 Total Dissolved Solids (TDS)
6 Input Water Temperature range
SPECIFICATION
®
AQUAGUARD CREST UV +HOT
315 mm X 185 mm X 425 mm (Approx.)
4.8 kg (Approx.)
UV
Combination cartridge (sediment + Carbon),
TM
Mineral guard , Active Copper
Booster Cartridge, UV- E-boiling
TM
Magnet Cartridge
20 Watts (Max.) in ambient mode.
785 Watts in HOT/Warm mode.
Input 230V AC, 50Hz.
11 Watts
8000 burning hours (as per UV lamp
manufacturer spec.)
150 to 280 V AC, 50 Hz
2
0.3 to 2 kg/cm
0.1 mg/L
0.2 mg/L
5 NTU
Up to 200 mg/L
10°C to 40°C
*Technical Specifications are subject to change without prior notice.
Note: The performance data presented in the table is applicable under
standard laboratory conditions
depending on the input water quality, water pressure and condition of
filters.
TM
with Zinc
**If the pressure is higher tan the maximum specified, use of a
TM
, Mineral
pressure reducing valve is mandatory, If the pressure is lower than
minimum specified, use an external booster pump recommended
The above accessories are available with our company at an additional
cost.
Warranty Void if the product is not installed as per
recommendations.
*
Standard Test Conditions:
Feed Water Quality: TDS Max: 200 mg/L
Pressure: 1 kg/cm
Chlorine: below 0.2 mg/L, Iron: below 0.1 mg/L
Life: 6000
Actual performance may vary based on input water conditions –
*
Turbidity& Pressure .
#
Actual performance may vary
.
2
, Turbidity: 1 NTU (Max.), Temperature: 25°C,
#
Liters