Table of Contents
Advertisement
Available languages
Available languages
Getting Started
[F/W UPDATE]
[UPDATE SYSTEM]
[F/W UP xxxx]
[YES]: Starts upgrading the firmware. ; [NO]: Cancels (upgrading is not
activated).
For details on how to update the firmware, visit
<https://www.kenwood.com/cs/ce/>.
• Once you have upgraded the firmware, you are unable to downgrade
the firmware.
[FACTORY RESET]
[YES]: Resets the settings to default (except the stored station). ;
[NO]: Cancels.
[ENGLISH]
Select the display language for [FUNCTION] menu and music information
[ESPANOL]
if applicable.
By default, [ENGLISH] is selected.
[FRANCAIS]
Radio
• "ST" indicator lights up when receiving an FM stereo broadcast with
sufficient signal strength.
• The unit switches to FM alarm automatically when receiving an alarm
signal from FM broadcast.
Search for a station
1
Press B SRC repeatedly to select RADIO.
2
Press BAND repeatedly (or press #FM+/
to select FM1/FM2/FM3/AM.
3
Press S / T (or press S / T (+) on the remote control) to
search for a station.
You can store up to 18 stations for FM and 6 stations for AM.
• To store a station: Press and hold one of the number buttons (1 to 6).
• To select a stored station: Press one of the number buttons (1 to 6)
(or press one of the number buttons (1 to 6) on the remote control).
AM– on the remote control)
*
7
ENGLISH
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the DPX505BT and is the answer not in the manual?
Questions and answers
Will not power up red light on left upper lights up and flashes fuse is good
The Kenwood DPX505BT may not be powering up despite the red light flashing and the fuse being good due to an improper wiring connection. The manual specifies that the red wire should be connected to the ignition 12V power source. If this connection is loose, disconnected, or improperly made, the unit may not receive the necessary power to turn on. Checking and ensuring a secure and correct wiring connection, especially for the ignition wire, may resolve the issue.
This answer is automatically generated
I accidentally set the language on my new Kenwood DPX505BT to Spanish during setup. How do I change it to English?
To change the language to English on a Kenwood DPX505BT:
1. Turn on the power. If it's the first time or after a factory reset, the display shows: “SEL LANGUAGE” “PRESS” “VOLUME KNOB”.
2. Turn the volume knob to select [ENG] (English).
3. Press the volume knob to confirm.
If the unit is already set up, you may need to enter the settings menu in STANDBY mode to change the language.
This answer is automatically generated
How to reset