NVC ODESSA V2 Instructions

Led floodlight

THANK YOU for buying this product. To help ensure it gives complete satisfaction please install it according

to these instructions and then pass the instructions to the appropriate person for retention and future

reference.

SAFETY This is a mains powered product. It is designed to be installed by suitably qualified personnel

only and in accordance with the applicable building and electrical regulations. Before installation or

maintenance the electrical supply to the product must be isolated.

INSTALLATION SUPPORT If installation advice or accessories are required please contact us at the above

address. We will do our best to help. When reporting a suspected fault or seeking installation support the

problem is likely to be resolved most quickly if you have full product details to-hand, as well as details of when

and where it was purchased.

LUMINAIRE INSTALLATION

1. Secure the luminaire into its required fixing position using the fixing holes/slots provided in the stirrup

mounting bracket (see diagrams above), ensuring the chosen method is sufficient to support the

luminaire weight.

2. To rotate the luminaire to the required angle, loosen the two hinge screws where the stirrup bracket

joins the main fitting with an allen key, rotate to required position, then retighten to secure.

3. The luminaire is supplied with a power supply lead already attached. Route the free end to a suitably

IP rated connection point (minimum IP65) & terminate ensuring correct polarity is observed.

WARNING: THIS LUMINAIRE MUST BE EARTHED

4. Reconnect power supply & check for correct operation.

The luminaire should be switched off & allowed to cool before any maintenance is carried out.

1. Cleaning of the glass front cover should be carried out at regular intervals so as not impair

photometric performance.

2. Dust should not be allowed to accumulate on the rear of the product as this will affect the thermal

performance of the heat sink.

ODESSA V2 LED FLOODLIGHT INSTRUCTIONS

Issue 04 on 5

March 2021

Table of Contents

Do you have a question about the ODESSA V2 and is the answer not in the manual?

Page 1 ODESSA V2 LED FLOODLIGHT INSTRUCTIONS Issue 04 on 5 March 2021 THANK YOU for buying this product. To help ensure it gives complete satisfaction please install it according to these instructions and then pass the instructions to the appropriate person for retention and future reference.
Page 2 To test cover the sensor and the fitting will come on, once uncovered the fitting will go off. • FAULT FINDING If you experiencing a problem please check through the following before making contact with NVC: Fault - Load does not come on Check to see if the live supply to the circuit is good.