Advertisement
Read this guide carefully and Keep this for your future reference.
N8104-161
QSFP+ Module (40G-SR4)
Precautions for Use
•Read carefully "Precautions for Use" in the manual of the LAN board, and observe the
instructions to ensure proper and safe use of this product.
This product is classified as a CLASS 1 LASER PRODUCT.
Contents
□QSFP+ Module
□Serial number label
□ User's guide
□ Warranty
•This warranty Card is available only for using in Japan.
Specification
Product Name
QSFP+ Module(40G-SR4)
Product Code
N8104-161
Data Transfer Rate
40Gbps ( 4 x 10G )
Type of Connector
MPO-type receptacle (1x12)
Voltage/Current
3.3V/0.35A
Temperature(C) 0-70
Operating condition
Humidity (%)
5-85
- This product is supported only for the servers
and options that is available for mounting
this product.
IMPORTANT:
- Keep the "Serial Number Label".
- Keep the removed "Dust Covers" for future
use.
EU Contact:
NEC Nederland
B.V.Olympia 4, 1213 NT Hilversum
The Netherlands
User's Guide
Descriptions
Dust cover(QSFP)
QSFP connector
Pull tab
MPO connector
Dust cover (MPO)
Disposing of your used product
In the European Union
EU-wide legislation as implemented in each
Member State requires that used electrical
and electronic products carrying the mark
(left) must be disposed of separately from
normal household waste. This includes
workstation or electrical accessories. When
you dispose of such products, please follow
the guidance of your local authority or ask
the shop where you purchased the product,
or if applicable, follow applicable legislation
RH
or agreement you may have. The mark on
(no condensation)
electrical and electronic products only
applies to the current European Union
Member States.
Outside the European Union
If you wish to dispose of used electrical and
electronic products outside the European Union,
please contact your local authority and ask for the
correct method of disposal.
Trademark, name and address of the manufacturer:
Finisar Corporation
1389 Moffett Park Drive, Sunnyvale, CA 94089,USA
1
Installation
1.
Remove the Dust Cover(QSFP) ,insert this product to the QSFP Slot of the
board .
QSFP Connector
Pull tab
To check the vertical direction of the
Align the module
module, Check the position of the port
with the QSFP slot of
number and the lamp. See the above figure.
the board.
2.
Remove the Dust Cover(MPO) ,insert the plug of an optical cable to MPO connector of this
module.
MPO Connector
Key
Pull tab
Plug of MPO cable
Key
Front view of the plug
Removal
1.
Remove the cable, and then attach the dust cover (MPO).
2.
Remove the QSFP module from the board, attach the dust cover (QSFP).
Grasp a part in the circle of the
MPO plug in the figure, pull in
the direction of the arrow.
NEC Corporation
This guide is made from recycled paper
Port ID "A"
QSFP Slot
A
Lamp
While holding a part in the circle
in the figure, insert the direction
of arrow, insert until a click is
heard.
While holding a part in the circle in
the figure, insert the direction of
QSFP Module
arrow, please insert until a click is
heard
Grasp the pull tab and pull to
release the latch, and then
remove the module.
7-1 Shiba 5-Chome, Minato-Ku
Tokyo 108-8001, Japan
1st. Edition
October 2016
Advertisement
