Defy Automaid 600 Washing Machine Manual

Technical specification

1. Lid
2. Option buttons
3. Temperature selector knob
4. Programme selector knob
5. Detergent dispenser
6. Door
7. Kick-panel
8. Kick-panel securing screw

Height: 850 mm.
Width: 600 mm.
Depth: 540 mm.
Net Weight: 66 kg.
Power requirement: 230V, 50 Hz.
Nominal current: 10 A
Power: 2250 W
Washing speed: 70 r/min
Spin speed: 600 r/min

The Manufacturer strives for continuous improvements. For this reason, the text and illustrations in this book are subject to change without notice.

Installation

Packaging

All packaging must be removed from the machine and disposed of in a responsible manner. Plastic bags and "Bubble wrap" sheets should be torn open to prevent children playing with them and accidentally suffocating.

Transport fittings

The wash drum is secured during transport to prevent damage.

Before using the machine, remove the transport fittings as follows:

1. Using a suitable spanner, loosen the three transport bolts ( C ) by turning them in an anti-clockwise direction until the bolts can be partially withdrawn.
2. Remove the bolts and the rubber bushes by pulling outwards. An up and down action together with a little dishwashing liquid will ease the removal.
3. Insert the three plastic plugs ( P ) supplied with the machine into the holes vacated by the transport fittings.

Note: To prevent damage, the machine should not be transported without the transport fittings securely in place.

Note: Never place the machine on a carpet. This could prevent air circulation and cause electrical components in the machine to overheat

Levelling

1. The machine must stand firmly on the floor. Any instability will negatively affect its performance.
2. The machine has two adjustable feet at the front.
3. To level the machine, loosen the plastic lock nuts on the adjustable feet.
4. Rotate the feet until the machine stands firm and level.
5. Tighten the lock nuts firmly.
6. 
   Never remove the lock nuts and feet from the machine.

Connecting to the cold water supply

1. The water supply should deliver 8 to 80 litres per minute.
2. Sealing washers are supplied and these should be fitted at either end of the inlet hose
3. Secure the angled end of the inlet hose to the water inlet at the rear of the machine and the straight end to a 3/4 inch BSP cold water tap.
4. Tighten both connections, open the tap and check for leaks.
5. We recommend that the tap be closed when the machine is not in use.

Water drainage

Draining into a dedicated outlet pipe (A)

1. The outlet pipe must have an inside diameter of at least 40 mm.
2. The end of the pipe must be positioned between 400 mm. and 1000 mm. above floor level.
3. Secure the hooked end of the drain hose into the outlet pipe.

Draining into a sink or bath (B)

1. The drain hose may be hooked over the edge of a sink or bath in such a way that the end can not be immersed in the collected waste water.
2. The outlet end of the hose must be between 40 cm. and 100 cm. above floor level.
3. Please note: The outlet hose must be kept free of kinks or restrictions as these will hinder the operation of the machine

Electrical connection

1. The power cord must be connected to a 15 amp earthed wall socket
2. Do not connect the machine through a double adaptor. It requires a dedicated power point
3. If the power cord should ever need replacing, use only a genuine cord ( Type 'X') available from the nearest Defy Service Centre.

The appliance must be earthed and the manufacturer and seller do not accept responsibility for any damage due to incorrect electrical connection.

The detergent dispenser

1. Open the dispenser
2. Place detergent / softener in the appropriate compartment of the dispenser, in accordance with the manufacturer's instructions
3. Detergent and additives will automatically be released at the appropriate time during the wash.
4. Concentrated softener may clog the siphon. In this case add some water to the softener liquid.
   

NOTE: Use only low foam detergents specifically designed for front loading washing machines

The control panel

1. Detergent dispenser
2. On / Off button
3. Rinse and Hold button
4. No spin button
5. Temperature selection knob
6. Programme selection knob

Features

Detergent dispenser

The detergent dispenser has 3 compartments.
Use only low foam detergents specifically designed for front loading automatic washing machines.
Dose as per the manufacturer's recommendations on the detergent pack.
Dosage may vary according to wash load, dirt and water hardness.

On / Off button

Push the button for power 'ON'
The door will lock and the indicator light will glow
Push the button once more for power "OFF'

Rinse and Hold button

Selecting this feature will stop the machine during the final rinse cycle with water in the tub. This prevents drip-dry, permanent press and wool articles from creasing caused by waiting in a 'dry' machine before being removed. To complete the programme, press the button once more or select (H) on the programme selector to discharge the water.

No spin button

Selecting this feature will eliminate the spin cycle from any selected programme.

Temperature selector

To access the temperature selector knob, push it gently to free it from the control panel. Select the temperature as indicated in the programme guide or a lower temperature if you desire. The knob is marked from 90°C to 30°C with indicating ambient tap water temperature.

Wash programme selector

Push to free the knob from the control panel. Turn the knob in a clockwise direction to select the desired programme.

Switch the machine off before turning the knob

Door

Open the door by gently pulling on the handle.
Close the door by pushing firmly until it clicks into place.

Note:
The door locks during the wash cycle
Switch the machine off and allow 1 to 2 minutes for the safety lock to disengage. ( a click sound will be heard )
Thereafter the door may be opened.

Helpful hints

• Sort washing by material type.
• Adhere to garment label washing instructions.
• Fasten zips to prevent them snagging other articles.
• Mend loose seams and tears before washing.
• Secure all loose buttons.
• Empty all pockets of coins and loose objects.
• Secure or remove brassiere wires.
• Wash small articles such as socks, handkerchiefs and delicate undies in a wash bag or pillow slip. This will prevent tangling.
• Treat any stains before washing.
• Test fabrics for colourfastness before washing.
• Wash new denim separately as colours may run.
• Wash new bulky articles such as quilts and sleeping bags individually. For best results use the WOOL programme.
• Do not wash articles which have been soaked in paint, petrol, thinners, or other flammable liquids.
• Do not wash rubberised articles such as rain coats and training shoes.
• It is important not to overload the machine as this will prevent it from washing properly.

Programme selection guide

PROGRAMME		DETERGENT COMPT	°C	LOAD Kg.	OPTION BUTTONS
					RINSE & HOLD	NO SPIN
COTTON AND LINENS			MAX 90
A WHITE PRE-WASH	HEAVILY SOILED	A –B-C	COLD To 90	5
B MAIN WASH	NORMALLY SOILED	B-C	COLD TO 90	5
X COLOUR FAST	LIGHTLY SOILED	B-C	COLD TO 60	5
M NON COLOUR FAST	VERY LIGHTLY SOILED	B-C	COLD TO 40	5
S COLD WASH	VERY LIGHTLY SOILED	B-C	COLD	5
C SPIN				5
SYNTHETICS			MAX 60
D PRE-WASH	HEAVILY SOILED	A-B-C	COLD TO 60	2.5
F MAIN WASH	NORMALLY SOILED	B-C	COLD TO 60	2.5
G RAPID WASH	LIGHTLY SOILED	B-C	COLD TO 40	2.5
N COLD WASH	LIGHTLY SOILED	B-C	COLD	2.5
H SPIN				2.5
WOOLLEN / DELICATE			MAX 40
J MAIN WASH	WOOLLENS	B-C	COLD TO 40	1.5
K DRAIN / SPIN				1.5

Note: During heating there may be a period (10 to 15 minutes) during which there is no drum rotation This is normal and should not be regarded as a fault.

Operating the machine

Sorting the laundry

Sort the laundry in one of the following groups:

1. White cotton and linen as well as robust colourfast fabrics.
2. Synthetics and synthetic blends as well as non colourfast fabrics
3. Delicate fabrics such as silks and rayon
4. Wool

Loading the machine

It is important not to overload the machine as this will prevent it from washing properly. You should be able to fit a hand between the top of the drum and the wash load in the drum.
The maximum recommended load of dry clothing that may be washed at one time in your Automaid is 5 kg.

Washing

1. Plug the machine in and switch on at the wall socket.
2. Open the water tap.
3. Check that the drain hose is in position and is free of kinks.
4. Open the door.
5. Load washing into the machine, distributing it evenly and loosely in the drum.
   DO NOT EXCEED THE MAXIMUM WASH LOAD AS DETAILED IN THE WASH GUIDE
6. Close the door.
7. Add detergents and additives to the relevant compartments in the detergent drawer and close the drawer.
8. Push the Temperature selection knob to free it from the facia. Select a temperature ( see wash guide) by turning the knob to the required setting. Push the knob back in to prevent accidental activation.
9. Push the Programme selection knob to free it from the facia. Rotate the knob in a clockwise direction to the desired programme. Do not attempt to turn the knob back if the programme is inadvertently bypassed, rather continue around the dial once more. Push the knob back in to prevent accidental activation.
10. Select any of the desired option buttons as detailed in the wash guide.
11. Push the power 'ON' button
12. The indicator light will glow and the machine will commence with the selected wash cycle.

Unloading the machine

1. The machine will stop automatically at the end of the selected cycle.
2. Switch off the machine and allow time for the safety lock to disengage.
3. Open the door and remove the wash load.
4. Gently rotate the drum by hand to check if all the laundry has been removed
5. Close the tap.
6. Leave the door slightly ajar to assist with drying and to prevent unpleasant odours from forming.

Care and maintenance

Detergent Dispenser

To remove residual detergent, pull the dispenser drawer outward, press on the marked area of the siphon, and pull the drawer free.
Wash the dispenser and the housing in water before re-inserting the dispenser.

Siphon

To prevent clogging, the siphon should be cleaned after every 30 to 40 washes.
Grasp the edges and pull the siphon free.
Clean away any residual softener and carefully re-fit the siphon.

Water intake filter

The filters at the water intake point prevent dirt from entering the machine and should be cleaned every 30 to 40 washes. To clean the filters, close the tap, disconnect the hose and clean the filters with a small nylon brush. If the filter is very dirty you may need to remove it with a pair of long nosed pliers.
To clean the filter at the tap side of the hose, pull it out by hand and rinse under running water.

Hoses

Periodically check the inlet and outlet hoses for leaks, perishing or cracks. In very cold conditions water in the hoses may freeze. In this instance, empty the hoses after the wash is complete.
Replacement hoses may be purchased from your nearest Defy Service Centre.

Cleaning the pump filter

A filter prevents foreign objects from entering and damaging the pump. This filter should be cleaned after every 30-40 washes. First disconnect the machine from the power supply. Use a large screwdriver or coin to turn the plastic fasteners in the kick panel through 90°. Place a shallow container below the filter outlet to collect any spillage. Remove the filter by turning it in a counter clockwise direction. Rinse the filter under running water.
Re-fit and secure the filter and kick panel.
If the filter cap is not fitted properly, water will leak from the machine.

General Cleaning

On no account use benzene or other solvents to clean the cabinet, door or rubber of the machine. A damp cloth will normally suffice. If desired, a good wax polish may be used on the metal parts of the cabinet.

International fabric care labels

Recommended washing temperature

Bleach can be used

No dry cleaning

Do not use bleach

May be washed in centrifugal machine

No spin

Do not wash in centrifugal machine

Wash by hand only

Dry on horizontal surface

Line dry

Do not wash

Dry clean

Ironing is permitted

Use a warm, Not hot iron

Do not iron

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Defy Automaid 600 Washing Machine Manual