Troubleshooting - AEG HVB75450IB User Manual

22 www.aeg.com
7.6 Periodic maintenance
Speak to your local Authorised Service
Centre periodically to check the

8. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
8.1 What to do if...
Problem
You cannot activate or oper‐
ate the hob.
An acoustic signal sounds
and the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
The hob deactivates.
The reset led indicator
blinks.
Hob²Hood function does not
work.
The sensor fields become
hot.
conditions of the gas supply pipe and the
pressure adjuster, if fitted.
Possible cause
The hob is not connected to
an electrical supply or it is
connected incorrectly.
The fuse is blown.
You do not set the heat set‐
ting for 20 seconds.
You touched 2 or more sen‐
sor fields at the same time.
There is water or fat stains
on the control panel.
You put something on one or
more sensor fields.
You put something on the
sensor field .
The reset procedure re‐
quired.
You covered the control pan‐
el.
The cookware is too large or
you put it too near to the
controls.
Remedy
Check if the hob is correctly
connected to the electrical
supply. Refer to the connec‐
tion diagram.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali‐
fied electrician.
Activate the hob again and
set the heat setting in less
than 20 seconds.
Touch only one sensor field.
Clean the control panel.
Remove the object from the
sensor fields.
Remove the object from the
sensor field.
Refer to "Control panel lay‐
out" (as if warning
pears).
Remove the object from the
control panel.
Put large cookware on the
rear burners if possible.
ap‐