Connecting Speakers; Am (Mw) Antenna - JVC UX-P55 Instruction Manual

AM (MW/LW) antenna
]
ANTENNA
1
2
AM loop antenna
(supplied)
1
Connect the AM loop antenna to the AM
LOOP terminals as illustrated.
2
Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM (MW/LW) antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. (The AM
loop antenna must remain connected.)
For better reception of both FM and AM (MW/LW)
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
]
Vinyl-covered wire
(not supplied)
AM EXT
AM LOOP
FM 75
COAXIAL

Connecting Speakers

1
Speaker
cord
Right
speaker
1
Press and hold the clamp of the speaker
terminal on the rear of the unit.
2
Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: Red (+) to red
(+) and black (–) to black (–).
• If the cords are covered with insulation,
remove a short section of insulation at the
end of each cord by twisting and pulling it
off.
3
Release the finger from the clamp.
• DO NOT connect speakers while the power is
on.
• DO NOT connect more than one speaker to each
speaker teminal.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
– 7 –
2
3
Red
RIGHT LEFT
MAIN
SPEAKERS
SPEAKER
IMPEDANCE
MIN 6
Black
Left
speaker
Speaker
cord