Mocon AMETEK Dansensor MAP Check 3 Vacuum User Manual page 42

40 User Guide
No.
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48*
49*
50
51
P/N 320598-G
11/2019
Type Message
Error Import/Export: no data found
Error Import/Export: corrupted data
Error Import/Export failed
Warning CO sensor needs calibration. Measuring values
2
may not be valid.
Warning O sensor needs calibration. Measuring values may
2
not be valid.
Error Cannot set mixer gas ratios. Mixer is not configured
for gases found in active product.
Error Unknown error from STM
Error Error from STM
Error Error from STM
Error Internal communication error
Error Internal communication error
Error External analog-digital converter failed
Error External analog-digital converter failed
Warning Atmospheric pressure sensor is not calibrated.
Pressure values may not be valid.
Warning Difference pressure sensor is not calibrated.
Pressure values may not be valid.
Error Voltage/current analog output failed
Error CO sensor communication error
2
Error CO sensor output out of range
2
Error Zr O : could not detect cold-junction temperature
2
sensor
Error Zr O : error with heater regulator
2
Error Zr O : cold-junction temperature sensor error
2
Error O sensor temperature out of range
2
Warning Too high O2 sensor temperature: XX C
Warning Too low O2 sensor temperature: XX C
Error O sensor is disabled because of hardware fail.
2
Please call service.
Error O sensor is disabled because of hardware fail.
2
Please call service.
EN Dansensor MAP Check 3 Vacuum
®
User action
User information
User information
User information
Contact service
for sensor
calibration
Contact service
for sensor
calibration
User information
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service
Contact service