DeWalt DCL510 Original Instructions Manual page 40

EngLIsh
b ) Never service damaged battery packs. Service of battery packs should only be
performed by the manufacturer or authorized service providers.
Additional Specific Safety Rules for Worklights

WARNING: Fire hazard. Do not operate worklight or charger near flammable liquids
or in gaseous or explosive atmospheres. Internal sparks may ignite fumes causing
personal injury.
• Do not expose light or charger to wet or damp areas. Do not expose light or charger to rain
or snow.
• Do not wash light or charger with water or allow water to get inside light or charger. Do
not submerge light in water at any time.
• Do not operate without lens cover assembly attached.

CAUTION: When not in use, place tool on its side on a stable surface where it
will not cause a tripping or falling hazard. Some tools with large battery packs will
stand upright on the battery pack but may be easily knocked over.
Chargers
D WALT chargers require no adjustment and are designed to be as easy as possible
e
to operate.
Electrical Safety
The electric motor has been designed for one voltage only. Always check that the battery
pack voltage corresponds to the voltage on the rating plate. Also make sure that the
voltage of your charger corresponds to that of your mains.
Your D WALT charger is double insulated in accordance with EN60335; therefore
e
no earth wire is required.
If the supply cord is damaged, it must be replaced by a specially prepared cord available
through the D WALT service organisation.
e
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in the plug.
• Connect the blue lead to the neutral terminal.

WARNING: No connection is to be made to the earth terminal.
38
SAVE THESE INSTRUCTIONS