SCM Olimpic K 1000 Instruction Manual page 392

RIP/4.2- MACHINING WITH STRAIGHT / RADIUS MILLERS RIP/4.2- MACHINING WITH STRAIGHT / RADIUS MILLERS
a) Set-up for thin edging machining (melamine, paper ...)
The correct group positioning (s. FIG.14) is automatically determined by the selection of the work
program (s. chap.7).
If necessary, rotate the hand wheels (FIG.15-REF.1 and 2) to set the values, corresponding to the
edging thickness and indicated on the plates (FIG.16-REF.1) on the numeric indicators (FIG.15-REF.3
and 4).
b) Set-up for thick edging machining (ABS, PVC, veneering ...)
The correct group positioning (s. FIG.17) is automatically determined by the selection of the work
program (s. chap.7).
14 15
RIP.22 EN
INSTRUCTIONS FOR USE AND MAINTENANCE