Image Source Selection Modes; Grayscale Conversion Modes - Barco Coronis Uniti User Manual

To enable/disable image scaling:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Image Source menu.
3. Enter the Scaling submenu.
4. Select Enabled/Disabled as desired and confirm.

4.24 Image source selection modes

About image source selection modes
Your Coronis Uniti automatically detects the number of video input signals connected, attaches them to the
correct display side and applies the correct video settings to it (resolution, video encoding mode, refresh
rate,...). However, it may be needed to manually select the video input signal(s) to be displayed on a certain
display side or to adjust certain video settings yourself. The start to this is selecting one of the following image
source selection modes available for your display:
• Automatic: In this mode, your display automatically detects the connected video input signals, attaches
them to the correct display side and applies the correct video settings to it (resolution, video encoding
mode, refresh rate,...). No video settings are available when this mode is selected.
• One Image Source: This mode is intended for displaying and manually configuring only one connected
video input signal. When selecting this mode, the video settings become available for the selected video
input signal.
• Two Image Sources: This mode is intended for displaying and manually configuring two connected video
input signals (one on each display side). When selecting this mode, the video settings become available
for the selected video input signal on each side of the display.
• Expert mode: This mode is intended for displaying and manually configuring one or two connected video
input signals. When selecting this mode, the video settings become available for both video input signals
on both sides of the display.
To select an image source selection mode:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Image Sources menu.
3. Enter the Image Source Selection submenu.
4. Select one of the available image source selection modes and confirm.

4.25 Grayscale conversion modes

About grayscale conversion modes
Grayscale conversion modes specify how color generated on the display controller is converted to grayscale
in your display.
The available grayscale conversion modes are:
• No Conversion
• Use Red Channel: This mode is intended for grayscale displays where gray is sent over the red channel.
• Use Green Channel: This mode is intended for grayscale displays where gray is sent over the green
channel.
• Use Blue Channel: This mode is intended for grayscale displays where gray is sent over the blue channel.
To manually select a grayscale conversion mode:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Image Sources > Input Settings > DisplayPort1/2 menu.
3. Enter the Grayscale Conversion submenu.
Advanced operation
K5902079 /11 Coronis Uniti 39