Sealey D43012V Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions
and maintained properly, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear Protective
Instruction Manual Gloves
1. SAFETY
 WARNING: this tank must ONLY be used for diesel fuel.
 Place the tank on a flat surface before filling.
 Secure the tank to strong points with ratchet straps before transporting in or on a vehicle.
 Maintain the pump in good condition (use an authorised service agent).
 Replace or repair damaged parts. Use recommended parts only. Non authorised parts may be dangerous and will invalidate the warranty.
 Keep the pump clean for best and safest performance.
 Ensure the power supply (vehicle battery) corresponds with the requirements of the pump (12V dc).
 Disconnect from battery when not in use.
 Wear protective gloves, and protective clothing when working around fuel. A full range of personal safety equipment is available from your
local Sealey dealer.
 Keep children and unauthorised persons away from the working area.
 DO NOT place the tank near any heat source.
 DO NOT start or stop the pump by connecting or disconnecting the battery clamps.
 DO NOT allow the unit to get wet.
 DO NOT operate the pump with wet hands.
 DO NOT use the pump where explosive or flammable vapours may be present.
 DO NOT tamper with the pump connections.
2. INTRODUCTION
Manufactured in Italy from HDPE for the safe transportation and dispensing of diesel fuel when supplying on site equipment. Complies to ADR
1.1.3.1.C for exemption from requirements of ADR regulations. Supplied with a 12V electric pump, 4mtr electric cable and clamps, security valve
and a 4mtr delivery hose with automatic fuel nozzle. Can be safely transported on a pick-up truck or van, with forklift points and 6 handles for
positioning. Supplied with a lockable cover. Not suitable for petrol.
3. SPECIFICATION
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .D43012V
Voltage: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12V
Current: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .22A
Power: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .140W
Tank Capacity: . . . . . . . . . . . . . . . . . . . . . . . . . . .430ltr
Flow Rate: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .40ltr/min
Dimensions (L x W x H): . . . . . . . . . . . . . . . . . . .1180 x 780 x 770mm
Lockable Cover:. . . . . . . . . . . . . . . . . . . . . . . . . .Yes
fig.1
© Jack Sealey Limited
INSTRUCTIONS FOR:
PORTABLE DIESEL TANK 12V
430ltr
D43012V
PART NO:
Key:
1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Filler Cap
2 . . . . . . . . . . . . . . . . . . . . . . . .Contents Gauge
3 . . . . . . . . . . . . . . . . . . . . . . . . . Security Valve
4 . . . . . . . . . . . . . . . . . . . . Pump On/Off Switch
5 . . . . . . . . . . . . . . . . . . . . .Battery Clip Storage
6 . . . . . . . . . . . . . . . . Dispenser Nozzle Storage
7 . . . . . . . . . . . . . . . . .Securing Strap Locations
Original Language Version
D43012V Issue: 1 - 09/02/16