Wingsland R6 User Manual page 4

Connecting your Aircraft
R6 remote controller support a wide range of WINGSLAND aircraft such
as S6、M5.Please follow the steps below to use the remote controller：
1. Power on the R6. Select and connect the R6 Wi-Fi in your mobile device
Wi-Fi list. The default Wi-Fi name is "wingslandR6_rc_xxxxxx" and the
password is "wingsland". Run the app when the Wi-Fi is linked up, then tap
"GO Start to Fly" to enter the main flying interface.
2. In the general setting, type in the aircraft Wi-Fi name and the password.
Then power on the aircraft, the remote and the aircraft will be linked up
automatically.
3. After the pairing, the aircraft can be only controlled by the remote controller.
Other features can still be active and set in the app except the virtual
joystick control function.
Connecting mobile device
Takeoff/Landing
Takeoff :
Hold the left button for 3 seconds to active the feature.

The aircraft will automatically hover up and stabilize.
Takeoff altitude: Indoor 1.2m, Outdoor 2.5m.
Landing: Hold the left button for 3 seconds, the aircraft will auto-
matically perform the landing. Check the landing area condition
and make sure no obstacle under the aircraft.
Photo/Video
Photo：Click the right button once to take one photo. A successful
prompt will be displayed in WINGSLAND FLY flying interface. The
burst mode can be set in the app for taking 6 photos at once.
3
The best working range
Weak signal
Setting
Choose aircraft
Choose aircraft please
Enter the password
Connecting aircraft
Strong signal
Confirm