Attaching The Tiltrotator - Engcon EC204 User Manual

4.3.1. Attaching the tiltrotator

Figure 7.
Figure 8.
Before installation
1. Check the tipping load limits. Take tiltrotator weight
and the extended risk area into account. Installation may
entail a necessary reduction in the volume of the tool.
2. Position the base machine and the tiltrotator on a flat,
non-slip surface. Make sure the tiltrotator is upright and in
line with the stick and break link.
3. If necessary, use a firmly planted ladder.
Installation
1. Fit any O-rings if such must be used.
2. Position the dog bone linkage to align with the
appropriate holes in the upper section of the tiltrotator.
3. Shim the width if necessary.
4. Insert the intended shaft journal.
5. Fit the shaft journal lock and make sure it locks
correctly.
19
4 Installation