Panasonic GT32-R User Manual page 50

○
Touch screen
1
Various screens are displayed here. A touch panel is provided on the liquid crystal display panel, and
switches can be operated and data entered simply by touching the panel.
Optional protective sheets are also available to protect the touch panel and keep it clean.
(A sheet is affixed to the touch panel to protect it from scratches when shipping. Please remove it before
using the GT.)
○
SD memory card slot (Except GT12M0 and GT12G0)
2
A SD memory card is inserted in this slot.
Saving from GTWIN: Operate on the GTWIN screen using a SD memory card read/writer.
-
Saving from GT main unit: Operate on the SD memory card setting screen under the system menu.
-
○
USB port
3
This is a connector for connecting the screen creation tool. The commercial USB cable can be used.
○
Ethernet port (RJ45) (GT32T1)
4
This is a connector for connecting the screen creation tool. The maximum baud rate is 115200 bps when
using Ethernet.
○
SPEED lamp (GT32T1)
5
It shows the baud rate when using Ethernet.
Light on: During 100Base communication
Blinking: During 10Base communication
○
LINK/ACT lamp (GT32T1)
6
it shows the state of communication with Ethernet.
Light on: When linked
Blinking: While data reception
○
Sound output jack (GT32T1)
7
Insert the speaker with a  3.5-mini plug amplifier for using the audio output function.
○
SD memory access lamp (Except GT12M0 and GT12G0)
8
The lamp turns on while accessing a SD memory card.
○
Battery cover
9
When using a backup battery to be separately purchased, open this battery cover to install it.
The clock, PLC device hold data, alarm history and GT internal device hold data functions can be used
with the backup battery.
○
Operation mode setting switches
10
Setting the operation mode setting switches as follows when turning on the power supply enables the
setting to inhibit to move to the system menu or enables to clear F-ROM.
Setting
Switch setting
The screen (backlight) flashes for a while when the F-ROM clear is executed.
Once the F-ROM clear is complete, the buzzer sounds and "Memory is cleared" is displayed on the
screen. Set the operation mode setting switches to the state in the normal use after confirming this
message, and turn on the power again.
Do not use any settings other than the above settings.
○
Mounting location of connector for battery
11
2-10
Normal use Inhibit system
(Factory default) menu shift
Clear F-ROM