Intermatic IG1CM Installation Instructions

SURGE PROTECTION
Telephone & Cable Indoor Stand Alone Protection

Models

Model Numbers:
IG2TM
IG4TM
IG1CM
Optional Modules
IG2T
IG1C

Parts List

Description
Mounting Frame
Cover / Back plate
IG2T (in Model IG2TM)
IG2T (2nd module in Model IG4TM)
IG1C(Coax module in model IG1CM)
Screws-self threading (3/8" Torx T20 / slot head)
Ground Wire
3/4" x 6 Pan Head Screws
3/4" anchors

Tools Required

Flat head screw driver, Torx T-20 head screw driver,
Awl or hole punch, drill, 1/8" and 3/16" bits.
G
A

Before Installing

1. This device is intended for surface mounting. If unit is to be flush mounted (inside of wall) make sure that you
have the FLUSH MOUNTING KIT, part number IGFLUSH.
2. Check the parts in the package against the Parts List shown above. Contact Intermatic if parts are missing.
3. It is suggested that you read these instructions completely before installing the Stand Alone Protection (SAP) unit.
Note: These modules rely on a good ground connection to function properly. Ground
availability should be a consideration when selecting an installation location.
Surface Installation
Description:
2-line telephone protector with indoor enclosure (NEMA 1)
4-line telephone protector with indoor enclosure (NEMA 1)
1-line coaxial cable protector with indoor enclosure (NEMA 1)
2-phone line protection module
coaxial cable protection module
Quantity
E
F
B
Do not install Protection Devices during Electrical Storms.
I
NSTALLATION
Reference
1 A
1 B
1 C
1 D
1 E
2 F
1 G
4 ( )
not shown
4 ( )
not shown
B
Notes:
1. Telephone protection is compatible with Voice
and Fax lines, Modem lines and DSL (Digital
Subscriber Lines.)
F
2. Coaxial protection is compatible with Local
antenna, Cable/Satellite and Cable Internet lines.
I
NSTRUCTIONS
A
C
D
G