Page 1
Instruction Manual RV Instantaneous Gas Water Heater ® WaterMark WMK26286 If the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. WARNING - Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. - WHAT TO DO IF YOU SMELL GAS ·Evacuate all persons from the vehicle.
Preface Respected user: Thank you for using our RV instant gas water heater. Correct installation and use of this product will bring new enjoyment to your RV lifestyle. Please read and follow all safety rules before installing and using this heater. Please keep the instructions safely for future reference.
Function ntroduction and Explanation The water heater is simple and convenient to operate. The microcomputer intelligent control system controls the whole process of the water heater. Press the key to start the water heater and set the required temperature. After the microcomputer intelligent control system detects the qualified water flow, it starts the ignition device.
Safety Warnings And Operational Safety Guidelines Please observe the safety warning information and operating safety instructions in this manual to avoid possible injury or death. Failure to comply with these warnings and safety guidelines can result in fire, explosion, and even death. lease only install it in recreational vehicles (RVs).
Page 5
8. Water heaters are used only for the supply of hot water and cannot be used for other purposes to prevent accidents. 9. Do not use the battery charger to power or test the water heater. The on-board power supply used by the vehicle-mounted gas water heater must be power supply complying with class 2 safety-isolated.
The installation must conform to one or more of the following as applicable: ●The following instructions are applicable to the Fogatti RV gas water heater. If you have any other questions about a particular installation or application, please consult to our company or the company authorized by our company authorised by us for installation and maintenance services.
Page 7
●Do not install this product under any overhanging structure such as awnings. ●This product should be installed in any place where the door will not be covered or blocked. If the condition is not allowed, you must limit the distance of the door to provide a minimum 160mm gap between the water heater vent and the door when the door is opened.
Page 8
●Valvess should be installed in gas pipe, inlet pipe and outlet pipe for easy maintenance. ●Check the gas leakage and water leakage after installation, make sure there is no any gas and water leakage. ●The minimum distance from the exhaust outlet to the flammable surface should be >500mm.
Page 9
●Model And Specifications Model FS06B1 Gas Intended for Universal LPG Total Nominal Gas Consumption 44.3MJ/h Number of Injector Injector Size 0.91mm Max. Working Water Pressure 0.8MPa Min. Working Water Pressure 0.1MPa Nominal Test Point Pressure 2.75kPa NominalManifold Pressure 1.28kPa Electrical Power 12VDC, <10 amp Water Heating Capacity(temp rise 25K) 6L/min...
Page 10
●Appearance 350mm 380mm 322.5mm Exhaust Flat lock Air Inlet grilles DC 12V Please use DC 12V RV battery Water Outlet G 1/2'' Gas Inlet SAE 3/8'' Water Inlet G 1/2''...
Page 12
Name Name Flat Lock Ignition Pin Front Panel Water Inlet Temp. Probe Decorative Ring Water Flow Sensor Blind Flange Relief Valve Fixing Plate Drain Pipe Fan Volute Gas Inlet Assembly Connecting Pipe for Housing Upper Hoarding Burner and Valve Wind Pressure Switch Gas Proportional Valve Housing Nether Hoarding Controller...
Page 14
WARNING This water heater is designed for RV users. The working voltage is DC 12V RV battery and the gas source is propane. Excessive force will damage the water heater's cold water and hot water connections. When installing the gas joint, tighten the joint with two wrenches to avoid damaging the water heater joint.
Page 15
Checking steps: 1. Confirm there is no leakage happening between any gas connections. For example, put soapy water on gas connection, to see whether there are bubbles. If there are no bubbles, it means noleakage;if bubbles occur, please check connections. 2.
Page 16
Product Wiring Diagram Water inlet temperature probe Water temperature probe Ignition pin assembly Water flow sensor Wind pressure switch Gas proportion valve Overtemperature protection thermostat Antifreeze thermostat Wired controller DC fan assembly DC 12V Switch Fuse box...
Operation Instructions ● DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN OPERATION. ● DO NOT USE OR STORE FLAMMABLE MATERIALS IN OR NEAR THIS APPLIANCE. ● DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE. ●...
Page 18
WARNING ●Children and juveniles are not advised to operate the water heater by themselves unless they are accompanied by a guardian. WARNING ●The door shall be kept closed during operation. The gas valve will be cut off after power off or power interruption. The user shall close thegas at the gas cylinder when power off or power interruption happens during operation.
Page 19
Wire Controller Instructions: 1. The wire controller emits a buzzer sound "B,B,B" when the power is turned on. The display shows the gas source code, and this code will only be displayed for 3 seconds. The wire controller's indicator light is on and the back light of power switch button is on. 2.
Fault Judgment And Processing Fault treatment: When the water heater fails, the display will show the fault code, and the buzzer will continuously issue alarms "B, B, B". Please follow the table below for the corresponding treatment. Error Code Cause Solutions When the system The outlet water temperature...
Page 21
Error Code Cause Solutions Replace the ignition feedback When the system needle assembly; The feedback pin is bent and is turned on in contact with other metal parts; Plug the feedback pin terminal wired controller correctly and firmly into the The feedback pin plug displays feedback pin;...
Page 22
Error Code Cause Solutions The gas supply pressure or gas composition does not match causing abnormal combustion; Confirm that the gas type and pressure meet the requirements The control program or of the water heater; parameter settings are incorrect Check whether the program resulting in abnormal combustion;...
Page 23
Error Code Cause Solutions During operation the fan speed continuously exceeds the set value of 5S speed; Check if the exhaust passage The outdoor wind pressure is is blocked When the system too high and the fan speed Stop starting and start after no is turned on or exceeds the upper limit of the...
Page 24
· It is not a failure when the following conditions occur: Example Reason and handling method When the outdoor temperature is too low, the exhausted smoke White smoke at exhaust encounters outdoor cold air and condenses into a white mist. If the water flow is too low, the water will become cold.
Maintenance ●SERVICE SHALL BE CARRIED OUT ONLY BY AUTHORIZED PERSONNEL AND THE APPLIANCE SHALL NOT BE MODIFIED For your comfort and safety,we recommend to check and maintain the product monthly. Disconnect the power supply and allow the unit to cool down before performing maintenance.
Page 26
The way to set minimum heat load: Method#1 1.Plug in electricity, it will show “O” 2.Press for 3 seconds,, it will show “PP” 3.Press to show FA; Press to show specifications: set the value to be 00. Press exit. 4.Press to show PH;...
Page 27
Here is the place to replace the spare parts: Servicing Centre:Australian RV Phone:03 97581761. we will direct you to your nearest service centre Parts Photo Parts Photo Lock Wind pressure switch Gas control valve Draught fan assembly Water flow sensor Burner Inflow temperature...
Drain And Store Instruction Water must be drained to prevent freezing during winter. 1. As shown in Figure 8, the water inlet connector is connected to the water outlet pipe with switch valve by a tee fitting. The water outlet connector is connected to the compressed air with switch valve using a tee fitting.
Antifreeze System Water heaters must be protected before travelling to a possible freezing environment. Freezing damage is not covered by the warranty. The anti-freezing function operation method is: 1. Drain away water inside the water heater. Applicable when the unit is not in use for long period.
The relevant provisions of the law provide you with quality services. To ensure your interests, please fill in the warranty card carefully. This warranty is only applicable to Fogatti RV gas water heater. 2. Customers who purchase products of Zhongshan Powtek Appliance Mfg. Ltd., the warranty period of each product of our company is (with the purchase certificate) (from the date of shipment) : one year (12 months).
Warranty Card User name Bar code number Product name Product model Purchasing date Warning! For your safety, please ensure that your installation conditions meet the following requirements: (applies only to water heater products) ● The power supply of the water heater must be reliably grounded and equipped with a leakage protection device to prevent accidental circuit leakage.
Need help?
Do you have a question about the FS-06-B1 and is the answer not in the manual?
Questions and answers