Troubleshooting - Mr. Entertainer KAR122C User & Safety Manual

PROBLEM
Unit is ON but there is low or no
volume
CD player of Karaoke System does
not work normally or the "No"
appears on the LED DISPLAY.
No sound - If audio is going through
TV/ home stereo
No song lyrics appear on the TV
screen (CDG Mode Only)
No image on TV screen
Cannot sing through the mic

TROUBLESHOOTING

POSSIBLE CAUSE
The master volume control has been
turned all the way down.
Disc is inserted upside down.
Disc is dirty.
Disc is scratched.
Disc is warped.
A non-standard disc is inserted.
Lens is dirty.
Moisture has condensed inside the
CD deck.
Karaoke system needs to be reset.
Source Selection on your TV/home
stereo is not set properly.
Improper connection to stereo
system or PA.
Video cable is not connected
properly to the TV.
Source selector on TV is not set to
VIDEO or A/V IN.
TV does not have video line input.
A CD+G disc is loaded but the CDG
indicator is not lit.
TV input is not properly set.
Improper MIC volume setting.
MIC is off.
MIC is not properly plugged in.
REMEDY
Turn the master volume control to a
higher output.
Insert disc correctly.
Wipe it clean with soft cloth.
Use a new disc.
Use a new disc.
Only use compatible discs
mentioned in this manual.
Clean the optical pickup with a CD
lens cleaner.
Wait about 20 to 30 minutes to let
it dry out.
Disconnect the machine from power
source for 30 seconds.
Select AV INPUT as the source for
your TV/home stereo.
Follow directions on 'Audio/Video
Output' section for connecting to a
home stereo system.
Connect the video cable to the
VIDEO OUT of the unit and to the
TV's Video In jack.
Use your TV Remote to select VIDEO
or A/V input.
Connect from VIDEO OUT of the unit
to a RF modulator and then to the
TV cable input.
Check the disc to be sure it is a
CD+G. Check disc to ensure it is
clean.
Set TV input to correct A/V input that
is connected to the unit.
Adjust MIC and MASTER VOLUME
CONTROLS to appropriate levels.
Turn on MIC with the ON/OFF switch
located on the microphone.
Insert the mic plug fully into either
MIC 1 or MIC 2 JACK of the unit
properly.