Calibration - NeoMedLight BiliCocoon Nest System Instructions For Use Manual

Overheating indicator –
continuous light
Overheating indicator –
flashing light
(Occurring while operating
within the specified
environmental conditions)
Irradiance out of specification
Light Box not working when plugged
to power supply and turned ON
Any other indication of malfunction
or damage
A.2.2 Annual Preventive Maintenance
The failure to perform the required preventive maintenance by the authorized technical staff
of the supplier – periodic verifications of the system – may cause:
System's failures
-
- Settings drifts
Warning
-
Malfunctions
which may lead to risks to the patient, the user, third parties or properties.
Dust filter is to be replaced (Section A.4) once per year during preventive maintenance.
A.3 Calibration
Before starting the operation ensure that the external power supply is not plugged to the
Light Box.
This operation should only be performed by the authorized technical staff of the hospital or
Warning
the supplier.
Calibration Procedure:
1. Check the irradiance before recalibrating the system (see the procedure in the Instructions for
Use) verifying if the irradiance value is in the calibration range: 39 – 42 µW∙cm
this range is not the same that is to be checked by the user). Continue with the calibration
procedure only if the irradiance is out of the calibration range.
IFU-BCC-SY-EnFr-2017-10-v13
Instructions for Use :
BiliCocoon™ Phototherapy System
Fan failure
Overheating –
the dust filter
may be damaged
or dirty
Un-calibrated
Device
The fuse may
have blown
Any other failure
Contact the supplier
Verify that the problem persists after
running the therapy at the operating
conditions specified in the Instructions For
Use and with the air inlets/outlets not
blocked. If it does persist replace the dust
filter as described in Section A.4.
Calibrate the system as described in
Section A.3
Replace the fuse as described in Section
A.5
Contact the supplier.
-2
EN
∙nm
-1
. (Note that
27