Fisher & Paykel DH9060P1 Troubleshooting Manual

Troubleshooting
The following is a list of problems you may encounter when using this appliance and some suggestions that may help to
correct the problem. If you still have problems, contact your Fisher & Paykel trained and supported service technician.
Problem
Pressing
'Power'
Fault with household
power supply.
does not turn on
the dryer
Dryer set to 'Cool Air'
cycle.
Dryer does not
Full water tank.
heat
The dryer has progressed
to 'Cool'.
Dryer door not closed
properly.
Is the dryer displaying a
Touching
user prompt or fault code?
Water tank full or not
does not start
properly in place.
the drying cycle
Lint filter needs to be
emptied.
Dryer is overloaded.
'Delay Start' function is set.
https://producthelp.fisherpaykel.com/au/Dry/Dryers/Heat_Pump/DH9060P1/User_Guide_DH9060P1/12_Troubleshooting
Possible Causes
Try plugging in and turning on another electrical appliance.
Check what cycle the dryer is set to (refer 'Drying cycles').
Change to preferred cycle.
Refer to 'Emptying the water collection tank'.
Check the progress — are 'Cool' or 'End' shown on the display?
Refer to 'Progress lights'.
Open and reclose the door. Check that the lint filter is correctly in
place and not obstructing the door.
Refer to 'User warnings' and 'Fault codes'.
Refer to 'Emptying the water collection tank'. Ensure the water
tank is properly in place.
Empty the lint filter and ensure it is correctly in place.
Remove some items from the dryer.
Refer to 'Delay Start' for more information.
What to do
Updated: Wed, 10 Nov 2021 13:46:44 GMT
Powered by
1