Table of Contents
Advertisement
the tube and turn it 90° clockwise, in order to permanently fix it in place.
•
Fix the first blower tube (4) to the air outlet using the screw (K) and its washers (L).
•
Align the second blower tube(5) compartment with the protrusion (P) of the first
blower tube, push the tube and turn it 90° clockwise, in order to permanently fix
it in place.
m Warning! Use only original manufacturer's replacement parts, accessories and attach-
ments. Failure to do so can cause poor performance, possible injury and may void your
warranty. Never use the machine without the guard assembled!
Leaf blower
Assembly: (Fig. 6 - 10)
m WARNINGS: The device must not be switched on or used until it has been fully assem-
bled.
Assembly vacuum collector (Fig. 10 - 14 )
Warning: The vacuum collector must not be used or switched on until it has been fully
assembled.
•
Remove the screw (K) and the washer (L).
•
Align the bent tube (18) with the projection of the air outlet, then slide the bent tube
over the air outlet and turn it over 90 ° counterclockwise to make it permanent to fix.
•
Insert the bent tube end into the capacity bag (17) and close the opening with the
hook and loop tape, which is fixed at the capacity bag (17).
•
The bent tube (18) with the screw (K) and the washers (L) secure to the air outlet.
•
Release the star grip (21) and remove the protection grid (22) to open.
•
Align the vacuum tube (19) with the projection from the inlet, slide the vacuum tube
in the direction of the projection and turn it 90° clockwise to fix it permanently.
•
Align the second suction vacuum tube (20) with the slide out the projection of the first
vacuum tube (19). After this put the two tubes together and turn them 90 ° clockwise
to make them permanent fix.
•
The engine can not start if you do not assemble the vacuum tube when using as a
vacuum.
Operation
Before starting
Each time before use, check the following:
•
That there are no leaks in the fuel system.
•
That the equipment is in perfect condition and that the safety devices and cutting
devices are complete.
•
That all screws are securely fastened.
Attachment and operating
AUS
17
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the FERREX LBH2600P and is the answer not in the manual?
Questions and answers