Summary of Contents for Airista Flow A1 Tag
- Page 1 AiRISTA Flow A1 Tag USER GUIDE Revision 1.0 a i r i s t a f l o w . c o m Copyright © 2020 AiRISTA Flow, Inc. All rights reserved.
-
Page 2: Table Of Contents
Contents General ..................... 3 Use Cases for the A1 Tag ...................... 3 Physical Features ........................4 Dimensions: ........................ 4 Weight: ........................4 Specifications ......................... 4 Environment: ......................4 Typical Operating Range: ..................4 Electrical Interface: ....................4 Certifications: ......................4 Supported Protocols: .................... -
Page 3: General
Use Cases for the A1 Tag The AiRISTA Flow A1 tag is a multipurpose BLE 4.2+ tag. The tag can be worn in a wristwatch type format or on a key tag/ pendant or it can be attached to an asset that need to be tracked. -
Page 4: Physical Features
FCC: Part 15. (See FCC Statement) CE: Europe. Supported Protocols: Cisco Support: LTX protocol support. iBeacon. Eddystone. a i r i s t a f l o w . c o m Copyright © 2020 AiRISTA Flow, Inc. All rights reserved. - Page 5 Tactile Push Button Multi-Color LED MAC address Optional Temperature and humidity sensor And/or 3 axis Accelerometer. a i r i s t a f l o w . c o m Copyright © 2020 AiRISTA Flow, Inc. All rights reserved.
-
Page 6: A1 Tag Activation And De-Activation
Press and hold the button for 5 seconds to force the tag to reset. This action will stop the tag process and the button needs to be pushed again to activate the tag. a i r i s t a f l o w . c o m Copyright © 2020 AiRISTA Flow, Inc. All rights reserved. - Page 7 Battery Replacement The A1 tag can be opened by prying the front and back of the clam shell enclosure away from each other. Do not insert any device in the square slot as that is where the sensitive humidity sensor is located.
- Page 8 When placing the A1 Tag PCB back into the enclosure make sure you line up the 2 alignment pins inside the mold with the holes in the PCB. After the battery was replaced close the A1 Tag by lining up the enclosure clips and then pressing the 2 parts of the enclosure together.
- Page 9 Bluetooth technology and that has the application to support it. It is recommended that you contact your AiRISTA Flow representative for more information on this process. These are the default settings for the A1 tag:...
- Page 10 The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. a i r i s t a f l o w . c o m Copyright © 2020 AiRISTA Flow, Inc. All rights reserved.
-
Page 11: Contact
913 Ridgebrook Rd. |Suite 110 |Sparks, MD 21152 Vaisalantie 6 | 02130 | Espoo Tel: 1-844-816-7127 Tel: +358-10-326-7600 info@airistaflow.com info@airistaflow.com a i r i s t a f l o w . c o m Copyright © 2020 AiRISTA Flow, Inc. All rights reserved.
Need help?
Do you have a question about the A1 Tag and is the answer not in the manual?
Questions and answers