Operation
Using cooling mode
1. Press the POWER on/off button on the control panel
36
on the remote control
The device switches on and the display
temperature.
2. Press the MODE button
the remote control until the mode indicator (COOL/DEHUM/FAN)
"COOL".
The device is in cooling mode.
3. Now press the TEMP- button
the desired temperature (temperature range: 16–31 °C).
If using the remote control: use the "TEMP+" button
37
to adjust the settings.
The set temperature flashes on the display and is saved after approx. 5 seconds.
4. Press the SPEED button
If using the remote control: press the "SPEED" button
The fan speed indicator (HIGH/LOW)
5. Press the POWER on/off button on the control panel or the "POWER" button on
the remote control to switch the device off.
The device switches off.
Using dehumidifier mode
When using the product in dehumidifier mode, you can remove the hot
air discharge hose
See the sections "Draining the water tank" and "Permanent water
discharge" for instructions on how to drain the integrated water tank.
1. Press the POWER on/off button on the control panel
36
on the remote control
2. Press the MODE button
the remote control until the mode indicator (COOL/DEHUM/FAN)
"DEHUM".
The device is in dehumidifier mode.
The temperature is automatically set to approx. 2°C below the currently
measured room temperature and is shown on the display
The temperature cannot be configured manually in this mode.
The air speed is automatically set to LOW and is indicated by the fan speed
indicator (HIGH/LOW)
mode.
16
12
to switch the device on.
25
on the control panel or the "MODE" button
27
/ TEMP+ button
24
on the control panel to set the fan speed.
19
14
.
12
to switch the device on.
25
on the control panel or the "MODE" button
19
. The fan speed cannot be configured manually in this
1
or the "POWER" button
21
shows the default/most recently set
28
on the control panel to set
33
and the "TEMP-" button
32
.
indicates the set speed.
1
or the "POWER" button
34
on
22
reads
34
on
22
reads
21
.
Need help?
Do you have a question about the Easy Home PAC2 and is the answer not in the manual?
Questions and answers