Blue By Adt Motion Sensor Ssm1R0-29 - Blue by ADT S40LR0-01 Setup Manual

Warning: the battery polarity must be observed. Improper handling of lithium batteries may result in heat
generation, explosion or fire, which may lead to personal injuries. Replace only with correct batteries.
Batteries must not be recharged, disassembled or disposed in fire. Disposal of used batteries must be in
accordance with the waste recovery and recycling regulations in your area. Keep away from small
children. If batteries are swallowed, immediately see a doctor. California only: The Perchlorate warning
only applies to Manganese Dioxide Lithium batteries sold or distributed in ONLY in California, USA.
Perchlorate Material – special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate.
4.5.

Blue by ADT Motion Sensor SSM1R0-29

Before you get started
You will need:
• Blue by ADT Smart Home Hub
• Blue by ADT app on the latest iOS or Android OS
• Phillips screwdriver or a drill with a Phillips driver bit (optional)
• Power drill with drill bits for pilot holes (optional)
Pairing
The Blue by ADT Smart Home Hub is the controlling hub that your sensors communicate with.
To pair your sensors with the Blue Smart Home Hub, just launch your Blue by ADT app. Once
logged in, select Menu > Devices > (+) Add Device > Sensors > Motion Sensor, and follow the
in-app setup help to pair your sensor.
Note: Sensors and devices in a Blue by ADT system are preconfigured so they will be pre-paired
to your system and can be added by simply removing the battery tab, as shown in the following
steps.
To enable a new sensor:
When the battery is inserted into the Blue by ADT Motion Sensor, the blue LED will blink for 90
1.
seconds, which indicates the pairing process is occurring.
If pairing is successful, the blue LED will be solid on for 3 seconds. If pairing fails, the red LED
2.
will be solid on for 3 seconds.
If pairing fails, press and hold the pairing button for 5 seconds to restart the pairing process.
3.
To make sure the detection function is working properly, a walk test should be performed
4.
annually.
Mapping location
This sensor is intended to be installed in accordance with the Standard for Installation and Classification
of Residential Burglar Alarm Systems, UL 1641.
Before selecting a position for the sensor, the following should be noted:
1. Do not position the motion sensor facing a window or direct sunlight.
2. The device is not suitable for use in drafty areas, such as where an air conditioner or fan is
installed. Excessive air movement may cause a false alarm.
3. Avoid aiming the sensor directly at heat sources like fireplaces, radiators, etc.
30 8/7/2020