List O F M Codes; M Code Descriptions - SODICK A320D Manual

Wire EDM Machine Operation
would be T84 - T85 to turn on or off high flushing, and T90 -T91 to cut and thread the
wire
The other T codes may be used if so desired, but the black switches on the control
normally activate them.
Code Description
M00 Program Stop
M01 Optional Stop
M02 End Of Program
M03 AWT Jump
M05 Sensor Touch Off pg. 10-7
M06 Disable EDM Power During Movement.
M33 Rotate Wire Tip Disposal Arm Forward. Use to remove the wire tip container.
M43 Rotate Wire Tip Disposal Arm Back.
M98 Jump to a Sub-Routine from the main program.
M99 Return from a Sub-Routine to the main program.
M C D
ODE ESCRIPTIONS
M00 Program Stop (If located at the end of the NC line it may not appear in graphics.
M01 Optional Stop (This Parameter in the SET screen must be set to ON to enable
recognition of M01 or by using FLAG2D1 in the program).
M03 AWT Jump : If the T91 operation fails (thread wire) at the present position, then
the program will be skipped up to the next M03 position. The M03 parameter in the SET
screen must be set to 1, for this code to be active. To use this function in your programs,
simply add the M03 code before the T90 codes.
Example:
G92X0 Y0
G29
M98P0000
M03 (This first M03 here is not really needed, but is OK )
T90
G00X1.500 Y2.500
T91
M98P0001
M03
T90
G00X2.500 Y2.500
T91
Copyright November, 98
L O M C
L O M C
I S T F O D
I S T F O D
If wire tread fails, then skip to next M03 code
Page 6-6
E S
E S
Chapter 6
Sodick Inc.