Do you have a question about the SP61071 and is the answer not in the manual?
Questions and answers
Summary of Contents for SP tools SP61071
Page 1
USER MANUAL SP61071 LI+ POWER BANK JUMP STARTER 700A RETAIN THESE INSTRUCTIONS AND ATTACH RECEIPT TO MANUAL FOR FUTURE REFERENCE NOTE: Proof of purchase must be retained by the customer as it will be required in the event of a claim under warranty.
Power-bank, with liquid crystal display allows users to accurately monitor the charge status percentage as well as read any warnings displayed due to incorrect operation. The SP61071 Li Power-bank, Jump-starter, automatically provides reverse polarity and short circuit protection, preventing serious battery damage, in the event of miss-connection.
Safety Instructions for Charger & Battery △ ! WARNING △! Do not use a damaged appliance. If the electrical cord of the charger is damaged have it repaired or replaced by a qualified electrician immediately. 2. Do not charge the Power-bank, Jump-starter inside a box or container;...
Intended Use • Only for use in non-explosive, dry environments. • Never use or put the unit down in any liquid, oil or water. As Jump starter: The Power-bank is intended for use on 12V petrol vehicles up to 6.0L, and 12V diesel vehicles up to 3.0L.
Technical Specification: Input: 15v / 1A Jumpstart 12V Output: Accessories less than 10 amps Mobile phones, Tablets, Camera’s 5V USB 2A output etc. Battery Capacity: 15000mAh (55.50Wh) Start Current: 250A Peak Current: 500A Operating Temp: -20°C ~ +60°C Full Charge Time: 5 hours Lifetime: >1000 cycles Dimensions: 181 x 95 x 40mm Weight: 610g...
Page 7
2. Li Power-bank Charging Instruction: The Li Power-bank can be connected to home (240v) or car charger (12v), once input power is connected the display shows "CHARGING". 240v charging: Plug the home adaptor into the 240v power point, then connect to the 15V 1A input port of the Li Power-bank.
Page 8
5. 12V Jump Start: Jump start 12V vehicle Instruction: Power-bank is at least 75% charged. Ensure 1. Insert the blue plug of the battery lead set into the host. 2. Connect the RED clamp to the vehicle's battery positive (+) terminal and connect the BLACK clamp to the vehicle's battery negative (-) terminal.
Page 9
Boost Function If your vehicles battery has no charge or a very low charge (less than 8.1V) your Li+ Power-bank will not automatically recognise that it is connected to a 12v battery. The Boost function allows you to manually connect the Li+ Power-bank battery to the output leads.
Frequently Asked Questions: Q. How do I turn it off? A. The unit will automatically power off: When charging is complete When no load is being drawn Q. How long will it take to charge the Li Power-bank? A. If about one third charged, approx. 3 hrs. using 15V1A input. Q.
To the extent permitted by law and subject to this Limited Warranty, and as part of the terms of the sale of the equipment or part thereof: SP Tools shall not be liable for any form of loss, damage, cost, injury or harm of any kind (whether direct, indirect, special or consequential) howsoever arising from the use or supply of the equipment to the purchaser.
Need help?
Do you have a question about the SP61071 and is the answer not in the manual?
Questions and answers