Do you have a question about the NA005 and is the answer not in the manual?
Questions and answers
Summary of Contents for Watergates NA005
Page 1
Electric Actuator NA005 acc. to annex VI of the Directive 2006/42/EC [Contact] [Fon & Web] Watergates GmbH & Co. KG Telefon: +49 - 5731 - 7900-0 Oberbecksener Str. 70 Telefax: +49 - 5731 - 7900-199 32547 Bad Oeynhausen (Germany) http://www.watergates.de...
Page 2
Watergates GmbH & Co. KG. This restriction also applies to the corresponding drawings. Watergates GmbH & Co. KG has the right to change parts of the actuator at any time without prior or direct notice to the client. The contents of this publication are subject to change without notice.
Initial commissioning of the Positioner PCU ................18 Fitting the housing cover ......................19 Operating modes ........................... 20 DEAD BAND ........................... 20 DELAY TIME ........................... 20 Manual operation mode....................... 20 Safety function (FAIL CLOSE / FAIL OPEN) ................20 A FULL ............................. 21 10.2015 - NA005-PCU http://www.watergates.de...
Page 4
Technical data ..........................23 10.2 Dimension ............................24 10.3 Wiring diagram NA005, 24V DC with option ALS and PCU, Version 1 ........25 10.4 Wiring diagram NA005, 24V DC with option ALS and PCU, Version 2 ........26 10.5 Wiring diagram NA005, 230V AC with option ALS and PCU, Version 1 ........ 27 10.6...
If you have any questions in relation to the positioner PCU, we shall be pleased to answer them. The telephone number will be found on the inside cover of these operation and installtion manual. Yours Watergates GmbH & Co. KG 10.2015 - NA005-PCU http://www.watergates.de...
• Stock-/ordering-/article-number • Description of the defect Guarantee For our positioner PCU we give a guarantee period in accordance with the sales contract. The warrenty and guarantee rules of Watergates GmbH & Co. KG are applicable. http://www.watergates.de NA005-PCU - 10.2015...
Paragraphs which are identified with this symbol contain very important advices; this also includes how to avoid damage to property. Observe these paragraphs without fail! This symbol indicates paragraphs which contain comments/advice or tips. This bullet identifies the description of actions which you should carry out. 10.2015 - NA005-PCU http://www.watergates.de...
Observe the respective relevant professional safety and accident prevention regulations when carrying out the mounting / repair work.. Check the correct functioning of the safety equipment (for example the emergency push off but- tons/ safety valves, etc)! http://www.watergates.de NA005-PCU - 10.2015...
When adjustments are being carried out on an opened and switch on (operational) limit switches, there is the risk that live parts(230V AC~) can be touched! Therefore the adjustment must be carried out only by the electrican or a person having adequate training, who is aware of the potential hazards. 10.2015 - NA005-PCU http://www.watergates.de...
The positioner shoud not be used outside or under wet conditions or in aresas with explosive atmosphere. Clean the positioner as required using a slightly moistened, soft cloth and a normal household cleaner. Do not use any abrasive corrosive or flammable cleaning agents! Do not use any high pressure cleaning devices. http://www.watergates.de NA005-PCU - 10.2015...
The non-observance of the mounting advices or the use outside the specified characteristic values can have negative influence on the functional reliability of the postitioner. The use of the positioner under the influence of radioactive radiation may take place after discus- sions with the manufacturer only. http://www.watergates.de NA005-PCU - 10.2015...
Do not damage the cover and /or the sealing rubber in the process. In this case, the degree of protection (IP68) would no longer be ensured! Fig. 7.1 -Electrical installation - Removing of the housing cover 10.2015 - NA005-PCU http://www.watergates.de...
The position of the terminals are in the sketch below. 2 4 6 8 10 12 1 3 5 7 9 11 Fig. 7.3 -Electrical installation - positions of the terminals http://www.watergates.de NA005-PCU - 10.2015...
Page 15
Ensure that the circumferential rubber sealing ring in the housing is not damaged and correctly seated in the groove Fit the housing cover and tighten the four screws. For this obsreve chapter: 8.5 „Fitting the housing cover“. Fig. 7.4 -Electrical installation - connection of the protective earth lead 10.2015 - NA005-PCU http://www.watergates.de...
By using the name plate determine the voltage level and type of motor drive voltage. For this see 4.3 „device variants“ in the mounting and operating manual for the electric actuator NA. http://www.watergates.de NA005-PCU - 10.2015...
An adjustment of the input signal and a programming of the positioner should make in the factory. Table 8.1 - Dip-switch: Input Signal switch Input Signal 4…20mA 2…10V 1…5V Fig. 8.1 - Adjustment / Starting - Dip-switch setting for the input signal 10.2015 - NA005-PCU http://www.watergates.de...
During the initialization process the valve/actuator drives into its open and close position. Take care that there won`t be insert any objects on limbs into the armature. Heavy injuries or demages http://www.watergates.de NA005-PCU - 10.2015...
- the circumferenctial rubber sealing ring in the housing is not damaged and is correctly seated in the groove Fit the housing covers onto the actuator and the positioner. Screw the housing covers tight using four screws and fit allen key. Attention! The max. torque of the bolts is: 0,5 Nm! 10.2015 - NA005-PCU http://www.watergates.de...
The actuator will stop, if there is no input signal. FAIL OPEN: The actuator will moves automatically into open position, if there is no input signal. FAIL CLOSE: The actuator will moves automatically into close position, if there is no input signal (not at 0…5/10V). http://www.watergates.de NA005-PCU - 10.2015...
CH 1 accordingly to the process described above. Sollwert w [%] The set value limit will be effective at a input signal range: 3...8 mA for CLOSE- position and 16...21 mA for OPEN-position. unlimited stroke limited stroke rated value w [%] 10.2015 - NA005-PCU http://www.watergates.de...
Input signal 20mA, actuator moves into OPEN-position, output signal 20mA. Sollwert w [%] REVERSE-function is activated,e.g.: Input signal 4mA, actuator moves into OPEN-position, output signal 4mA. Input signal 20mA, actuator moves into CLOSE position, output signal 20mA. FALL RISE rated value w [%] http://www.watergates.de NA005-PCU - 10.2015...
Need help?
Do you have a question about the NA005 and is the answer not in the manual?
Questions and answers