Configuring An Ntp Server; Setting Daylight Savings Time - Cisco SFS 3504 Installation And Configuration Note

Configuring the Cisco SFS 3504 Server Switch

Setting Daylight Savings Time

To configure daylight savings time, perform the following steps:
Enter the enable command to enter privileged EXEC mode:
Step 1
SFS-3504> enable
SFS-3504#
Enter the configure command to enter configuration mode:
Step 2
SFS-3504# configure
SFS-3504(config)#
Enter clock summer-time command:
Step 3
SFS-3504(config)# clock summer-time
Save the configuration to preserve it between reboots by entering the exit command to return to
Step 4
privileged EXEC mode and by entering the copy running-config startup-config command:
SFS-3504(config)# exit
SFS-3504# copy running-config startup-config
To undo the daylight savings time configuration and revert to standard local time, use the no form of the
clock summer-time command.

Configuring an NTP Server

To configure your Cisco SFS 3504 Server Switch to obtain time and date information from a Network
Time Protocol (NTP) server you must assign an NTP server. To assign an NTP server, perform the
following steps:
Enter the enable command to enter privileged EXEC mode.
Step 1
SFS-3504> enable
SFS-3504#
Enter the configure command to enter configuration mode.
Step 2
SFS-3504# configure
SFS-3504(config)#
Enter the ntp command with the server-one keyword and the IP address of the primary NTP server, as
Step 3
shown in the following example:
SFS-3504(config)# ntp server-one 10.2.0.50
For more information, see the Cisco SFS Product Family Command Reference.
Save the configuration to preserve it between reboots by entering the copy running-config startup-config
Step 4
command:
SFS-3504(config)# exit
SFS-3504# copy running-config startup-config
Cisco SFS 3504 Multifabric Server Switch Installation and Configuration Note
18
78-18335-01