Smogtec esi 24 User Manual

e s i
e s i
esi 24 - Electromagnetic Field Indicator/
with high-precision HF mode (15 LEDs)
HF frequency range 50 MHz to 8 GHz – superb WLAN detection
Thank you for purchasing this esi 24 electrosmog indicator. You have made the right choice.
The electromagnetic environment has become very dynamic and regular checks are highly
advisable as a precautionary measure. The esi 24 is ideally suited to this purpose. Please
read the following instructions carefully and keep them safe for future reference.

Setting up the esi 24 electrosmog indicator

• Inserting/changing the battery:
Open the battery compartment, attach the 9 V battery to the contacts and insert battery into the battery compartment.
Note: Ensure that the battery cable does not become trapped under the battery but instead lies between the battery
and the side of the compartment. Not doing so may prevent the battery compartment from being properly closed or
cause damage to the cable.
• Switching the unit on
To switch the unit on press the on/off button briefly once.

The battery check is activated and an LED lights up for half a second to indicate
battery status: green for 25-100% charged, red for < 25% (change battery soon)
and flashing red for battery low (in this situation the unit shuts down
automatically)

LEDs light up green-yellow-red in quick succession for each field type (function
test)

Loudspeaker is activated
After start-up the esi 24 EMF indicator enters the
Switching off audio signal: To switch the audio signal off or on, hold the on/off switch down once for a few
seconds.
Switching the unit off: To switch off the esi 24 press the on/off button once briefly.
• Holding the unit correctly
To ensure best operation of the esi 24 Indicator, hold
the unit by the bottom end with your arm stretched
away from your body. You may otherwise block some
of the sensors and thus cause an incorrect reading.
Hold the unit as still as possible during measurements,
as the esi 24 requires a little time to capture new
readings for each field type and calculate the correct LED
activations.

• Standard operating mode of the esi 24

2 4
2 4
-
-
Standard operating
Proffsmagasinet
U s e r M
U s e r M
Electrosmog Indicator
mode.
Right!
a n u a l
a n u a l
Wrong!