Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Clearbox nControl
- Page 1 Configuration Tool User Manual Revision: 0.1 Clearbox Work Instruction Configuration Tool User Manual Document No: CBX-NCTL-001 0.1 Release History Version Name Date Change Details Jeremy Hallett 02-Nov-2009 Initial Draft Clearbox Systems Pty. Ltd. |Commercial In Confidence 1/ 6...
- Page 2 ONTENTS 1. SCOPE ................................3 1.1 D ............................3 OCUMENT URPOSE 2. OVERVIEW ..............................3 3. INSTALLATION .............................. 3 4. USING NCONTROL CONFIGURATION TOOL ....................4 4.1 D ........................... 4 ISCOVERING N ONTROL NITS 4.2 C ........................5 ONFIGURING AN N ONTROL 4.2.1 Identifying Information ......................
- Page 3 The nControl Configuration Tool provides a means to configure the network settings of an nControl with an unknown IP address. The nControl Configuration Tool is installed on all new nControl units. It automatically runs on boot and allows for configuration of eth0, the Ethernet port physically located furthest from the power supply.
- Page 4 When the configuration tool is run the main window appears as seen in Figure 2. This window consists of a menu bar, a table which will contain entries of each of the nControl units discovered, and two buttons to refresh the table and to configure a selected unit.
- Page 5 Figure 4: Table populated with discovered nControl unit. 4.2 Configuring an nControl Unit To configure the network settings of an nControl unit either select a unit in the table and click “Configure Selected Device” or double click on the line in the table. The “Remote Device Settings”...
- Page 6 IP address. 4.2.3 Save Changes Once the settings are configured as required click “OK” for them to take. A confirmation window will appear to confirm the changes. Clearbox Systems Pty. Ltd. |Commercial In Confidence 6/ 6...
Need help?
Do you have a question about the nControl and is the answer not in the manual?
Questions and answers